WAVE
DTX700 Reference Manual
54
Wave Trimming
Start
This is the position at which playback will start. In other words,
no data in front of this point (i.e., with a smaller position value)
will be played.
Settings:
00000 and higher
Loop
This is the position at which looping will start. If “loop” has been
selected for the PlayMode parameter (also from the Menu area’s
Wave/Common page), playback will loop continuously between
this point and the end point.
Settings:
00000 and higher
End
This is the position at which playback or looping will end. In
other words, no data behind this point (i.e., with a larger position
value) will be played.
Settings:
00001 and higher
Decay
Use this parameter to set the rate at which the playback volume of
the wave decays. At a setting of 127, the volume remains con-
stant. Lower values produce a faster rate of decay. This setting
applies to both one-shot and looped playback modes.
Settings:
0 to 127
Hi-hat Control Sensitivity (HHCtrlSens)
Use this parameter to specify how the playback volume of the
wave decays in response to operation of a hi-hat controller con-
nected to the [HI-HAT CONTROL] jack. The smaller the value,
the faster the rate of decay.
Settings:
-64 to +0 to +64
Wave Name (Name)
Use this parameter to set a wave name of up to 10 characters in
length. Move the cursor within the name field using the [F1] and
[F3] buttons and select a character for that position by turning the
dial. The following characters can be used.
NOTE
•
If you hold down the [SHIFT] button and press the [F1] or [F3]
button, the cursor will move to the start or end of the wave
name field.
•
If you hold down the [SHIFT] button and press the [-/DEC] or
[+/INC] button, or alternatively, hold down the [SHIFT] button
and turn the dial, the cursor will jump between the “
”, “0”, “A”,
“a”, and “~” characters.
WAVE/COMMON 2/3
WAVE/COMMON 3/3
