Sampling Mode [SAMPLING]
Reference
DTX900 Owner’s Manual
139
Dr
um Kit mode
Ref
erence
Song mode
Clic
k mode
Tr
igger mode
File mode
Utility mode
Chain mode
Sampling mode
Trimming a User Voice
[F3] TRIM
From this display, you can use the Trim function to delete unwanted portions of the User Voice selected on the [F1] SELECT
display, located ahead of the Start point and located after the End point.
1
Press the [SAMPLING] button to enter the
Sampling mode.
The Sampling Select display appears.
2
Select the User Voice to be trimmed on the
[F1] SELECT display.
3
Press the [F3] TRIM button to call up the
Trimming display.
1
Start (Start point)
Determines the Start point for playback of the audio data
included in the User Voice. The portion of the audio to the left
of this point will not be played back. When the cursor is
located on the Start parameter, the Start Point is indicated as a
vertical full line in the waveform display. When the cursor is
not located on the Start parameter, the Start Point is indicated
as a vertical dotted line in the waveform display.
B
Loop (Loop Point)
Determines the Loop point at which loop playback starts.
When the Play mode is set to “loop,” the audio data included
in the User Voice is played back between this Loop point and
the End point. When the cursor is located on the Loop param-
eter, the Loop Point is indicated as a vertical full line in the
waveform display. When the cursor is not located on the Loop
parameter, the Loop Point is indicated as a vertical dotted line
in the waveform display.
C
End (End Point)
Determines the End point for playback of the audio data
included in the User Voice. The portion of the audio to the
right of this point will not be played back. When the cursor is
located on the End parameter, the End Point is indicated as a
vertical full line in the waveform display. When the cursor is
not located on the End parameter, the End Point is indicated
as a vertical dotted line in the waveform display.
D
Play Mode
Determines how the selected User Voice is to be played back.
oneshot The User Voice plays back one time from Start
point to End point. This setting can be used for
solos, sound effects and vocal passages that
are used once without looping.
reverse
The User Voice plays back one time in reverse
from End point to Start point.
This is useful for creating reversed cymbal
sounds and other special effects.
loop
The User Voice plays back begins from the Start
point, continues to the Loop point, then repeats
indefinitely between the Loop point and End
point. This setting is useful for short rhythmic
passages, riffs and beats that you want to play
back repeatedly and continuously.
NOTE
• When a User Voice having no audio data is selected on the [F1]
SELECT display, pressing the [F3] button cannot call up the Trimming
display.
1
6
7
8
9
J
5
2
3
1
2
3
4
K
Settings
oneshot, reverse, loop
Start Point
End Point
Start Point
End Point
Start Point
End Point
Loop Playback
Top Point
