Drum Kit Mode [DRUM KIT]
Reference
96
DTX900 Owner’s Manual
From this display, you can perform the MIDI settings
called up when the current Drum Kit is selected. According
to the settings here, MIDI messages for 16 channels will be
transmitted to the internal tone generator or the external
MIDI device via MIDI when the current Drum Kit is
selected. This display consists of five pages.
First page
1
TG SW (Tone Generator Switch)
Determines whether or not the MIDI messages will be trans-
mitted to the internal tone generator when the current Drum
Kit is selected. When set to on, selecting the current Drum Kit
transmits the MIDI messages for the corresponding channel
to the internal tone generator according to the settings at
3
–
K
.
B
MIDI SW (MIDI Switch)
Determines whether or not the MIDI messages will be trans-
mitted to the external tone generator via MIDI OUT for each
MIDI channel when the current Drum Kit is selected. When
set to on, selecting the current Drum Kit transmits the MIDI
messages for the corresponding channel to the external tone
generator via MIDI OUT according to the settings at
3
–
K
.
Second page
C
TRANSMIT
Determines the type of MIDI messages transmitted to the
internal tone generator or external MIDI device. When “off”
is selected, no MIDI message will be transmitted even if the
TG SW and MIDI SW parameters are set to on. When “all” is
selected, both Program Change and Control Change messages
will be transmitted. When “PC” is selected, only Program
Change messages will be transmitted.
D
VOLUME
Determines the value of the Volume (Control Change number
7) for each MIDI channel.
E
PAN
Determines the value of the Pan (Control Change number 10)
for each MIDI channel.
Third page
F
VCE NUM (Voice Number)
Determines the Program Change number for each MIDI chan-
nel.
G
BANK MSB/LSB
Determines the Program Change number (by Bank MSB/LSB
values) for each MIDI channel.
Fourth page
H
REV SEND (Reverb Send)
Determines the value of the Reverb Send Level (Control
Change number 91) for each MIDI channel.
I
CHO SEND (Chorus Send)
Determines the value of the Chorus Send Level (Control
Change number 93) for each MIDI channel.
Fifth page
J
CC NUM
Determines the Control Change number for each MIDI chan-
nel.
K
CC VALUE
Determines the value of the specified Control Change number
for each MIDI channel.
MIDI Settings
[SF3] MIDI
Settings
Off, On
Settings
Off, On
Settings
Off, All, PC
Range
0 – 127
Range
L63 (far left) – C (center) – R63 (far right)
1
2
4
3
5
Settings
1 – 128
Settings
0 – 127
NOTE
• For details about the Bank MSB, Bank LSB and Program Change
messages and how they determine the Voice of the DTX900, refer to
the Voice List in the separate Data List booklet.
Range
0 – 127
Range
0 – 127
Settings
Off, 1 – 95
Range
0 – 127
NOTE
• If you set a Control change event
JK
that duplicates the VOLUME
4
, PAN
5
, REV SEND
8
, or CHO SEND
9
setting, the Control
Change event
JK
will take priority.
6
7
9
8
K
J
