30
DTXPRESS
2-2. Press the [PAGE ] button several times to call up the
UTIL8 page.
2-3. From the page shown above, press the [SAVE/ENTER]
button to call up the prompt shown below, asking for
confirmation of the Factory Set operation.
*
To cancel the Factory Set operation, press any button except
for the [SAVE/ENTER] and [SHIFT] buttons (the jog dial
can also be used to cancel the operation).
2-4. Once again, press the [SAVE/ENTER] button to proceed
with the operation.
[Note]
Please proceed with caution, since executing this operation
will also rewrite the entire memory contents of the
DTXPRESS
(all Click Sets, User Trigger Setups 8–11,
User Drum Kits 51–70, User Songs 64–83, Utility data)
with the data that was set in the unit’s memory when it
was shipped from the factory.
■
FACTORY SETTING
• VOLUME : MIN.
• POWER switch : OFF (
?
STANDBY)
UTIL8
π
Factory
Set
All
data
will
be
lost.AreYouSure?
All
Memory
Initializing...
Inspecting the Unit for Sound Production
1. In the normal operation state, set VOLUME to MAX and
check that the noise level meets following conditions.
OUTPUT (L/MONO): -75dBu or lower (load of 10k
Ω
)
OUTPUT (R): -75dBu or lower (load of 10k
Ω
)
PHONES (L): -75dBu or lower (load of 33
Ω
)
PHONES (R): -75dBu or lower (load of 33
Ω
)
2. Connect both OUTPUT L/MONO and R to powered speakers
and turn on the power. Press [SONG] 2 times and check that
the music is output and that the sound is not distorted.
3. Turn VOLUME to MIN and MAX and check that the sound
volume varies from the minimum to maximum level.
4. Press [SONG] and check that the music stops.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
