Edit Section
44
[TrgCopy1] & [TrgCopy2] Trigger Copy
You can copy trigger settings to create a drum kit for a similar
configuration of pads. Use the [TrgCopy1] page to copy
settings from a specific trigger input. Use the [TrgCopy2]
page to copy setting from the drum kit you are currently
working (editing) with. Either copy operation is done simply
by selecting a target and pressing the ENTER/YES button.
Copying from a Trigger Input
1
(from) Input
Select the source trigger input.
❏
Settings:
1~16
2
(to) Kit
Select the destination drum kit. Select current when copying
to the current drum kit.
❏
Settings:
current, U1~U40
3
(to) Input
Select the destination trigger input of the drum kit
2
.
❏
Settings:
1~16
Copying from the Current Drum Kit
1
(to) Kit
Select the destination drum kit.
❏
Settings:
U1~U40
Copy Operation
When you select the source and destination, press the
ENTER/YES button. An “Are You Sure?” confirmation
message will appear in the display. Press the ENTER/YES
button again to actually execute the copy operation. Press the
EXIT/NO button to cancel. When you return to the copy
page, continue copying if desired, or resume making trigger
settings.
[MIDIEG] MIDI Envelope Generator
In this page, you can create a MIDI-controlled EG, triggered
from a pad head or rim (page 39). This is a function that
outputs the specified Control Change data values
continuously and controls them transitionally in an envelope
curve. You can use this, for example, for real-time control of
the stereo panning or volume level of sustained sounds from
an external synthesizer or the built-in tone generator.
1
Curve
Select from 8 different envelope curves. As shown in the
diagram above, different Control Change values will be
output in a transition time
2
in the envelope curve specified
here.
❏
Settings:
1~8
2
Time
Determines the transition time when the envelope curve
1
comes into effect. The larger the value, the longer the elapsed
time.
❏
Settings:
0~127
3
MIDI
Determines the MIDI channel used to output the Control
Change data.
❏
Settings:
1ch~16ch
4
Type
Determines the Controller number used to output the
Control Change data.
❏
Settings:
Ctl0~Ctl119
n
For more information on available controller numbers, refer to the
Controller Number List in the separate Data List.
[TrgCopy1]Input Kit Input
from 16 to current 16
1
3
2
[TrgCopy2]Copy Current Trigger to Kit
U1
1
[MIDIEG] Curve Time MIDI Type
3 -- 32 1ch Ctl 16
1
3
4
2
Control Change value
Example: Curve 3
Time
0
