Edit Section
50
S e t t i n g a n E x t r a S n a r e D r u m
Extra Snare is a special snare drum voice that you can
select when you specify XtrSnr for the voice category.
Moreover, you can customize the snare drum using the
following parameters. (These cannot be set with other
voices, and “----” is shown in the display.)
Special snare drum is a two-layered composite voice,
which is created by combining two different drum
voices, adjusting the volume balance between these
voices, and modifying the composite voice tone using
the Filter and Decay parameters. If you use a
TP120SD or TP100 pad for the snare drum, you can
also use the pad controller to dynamically adjust one
of the following parameters for a dynamic tone change
(page 37).
1
Wave1
Select a drum voice for the layer 1.
❏
Settings:
Mapl1370, MCAbs55, MCVint55, Beech55,
Maple55, Alumin55, Brass35, Brass55, Brass65,
Steel65, Bamboo, FRPSnr
2
Wave2
Select a drum voice for the layer 2.
❏
Settings:
warm, crisp, cool, short, punchy, BS, silky, bright,
old, VOX1, VOX2, VOX3, roll, trash
3
XSfilter
Specifies the filter effect.
❏
Settings:
thru (no effect), type1, type2
4
XSdecay
Adjusts the duration of your snare drum.
❏
Settings:
off (no effect), 1~32
5
Balance
Adjusts the volume balance between the layer 1 and 2
sounds.
❏
Settings:
–64~0~+63
[Voice3] Pan & Tone
This page lets you adjust the stereo panning and filter of the
voice assigned to the note number. If you selected a two-
layered voice, you can also specify the volume balance
between the layers.
1
Note Number & Name
Determines a target note number (13~94: C#-1~A#5). Each
note number is shown with a specific note name.
2
Pan
Determines the pan setting for the voice assigned to the note
number
1
. This setting determines the stereo position of the
voice.
❏
Settings:
L64~C~R63 (left to center to right)
3
Layer
Specify the volume balance between layers if you selected a
two-layered voice for the note number
1
. If the voice is not
two-layered, the parameter cannot be set and “---” is shown in
the display.
❏
Settings:
–64~0~+63 (100:0~50:50~0:100)
4
Filter
Determines the filter setting for the voice assigned to the note
number
1
. This is a low-pass filter that cuts the frequencies
higher than the cutoff point specified here and passes the rest,
as shown in the diagram below.
❏
Settings:
–64~+63
5
Q
Adjust the Q (bandwidth) factor for the filter
4
. Boosting
the frequencies around the cutoff point as shown in the
diagram below makes the filter peak sharper and more
pronounced.
❏
Settings:
–64~+63
Wave1 Wave2 XSfilter XSdecay Balance
Mapl1370 warm type1 32 0
1
4
5
3
2
[Voice3] Pan Layer Filter Q
49C#2 R13 +63 +63 +63
1
4
5
3
2
Frequency
Cutoff point
Blocked frequencies
Low-pass filter and frequencies
Frequencies
passed by the filter
Level
Level
Q (Q curves)
Frequency
Q max.
Q min.
