Edit Section
57
[Effect] Effect Basics
Press the EFFECT button on the top panel, designated by
DRUMKIT, to start editing effect settings for the drum kit
you are currently working with.
n
The first page that appears (the one last called up) may be different
from the display shown above (page 76).
1
Localizer
Enable (on) or disable (off ) the Localizer.
❏
Settings:
on, off
n
When the Localizer is enabled, you can use only the system reverb
effect for other effects. Since you cannot use system chorus and
insertion effects, their respective edit pages will not appear. If the
Localizer is disabled, its edit pages will not appear instead.
2
RevSend
Determines the send level to the system reverb effect for the
entire drum kit. This works as a master level to reverb send
levels for the drum voices (page 53).
❏
Settings:
0~127
3
ChoSend
Determines the send level to the system chorus effect for the
entire drum kit. This works as a master level to chorus send
levels for the drum voices (page 53).
❏
Settings:
--- (disabled when the Localizer is enabled), 0~127
n
RevSend
2
and ChoSend
3
only work for rhythm part (MIDI
channel 10) from the built-in tone generator. These are equivalent
to the reverb send and chorus send levels (page 54) available when
transmission to MIDI channel 10 is enabled.
[Reverb] System Reverb Effect
Configure the system reverb effect. This setting data will be
sent to the built-in tone generator when you recall and play
the drum kit you are currently editing. This setting data is
shared not only with each drum voice (MIDI channel 10),
but also with all other parts from the built-in tone generator.
1
Type
Select a reverb type. For system reverb, you can choose from
the following 12 types. Select NONE if you want to
temporarily disable the system reverb.
❏
Settings:
NONE, HALL1~2, ROOM1~3, STAGE1~2, PLATE,
WHITEROOM, TUNNEL, CANYON, BASEMENT
For detailed explanations of the other parameters, refer to the
Effect Type List in the separate Data List. Note that the same
parameter name may not always represent an identical
function.
n
System reverb effect offers a single reverb effect specified here to all
parts from the built-in tone generator. Use an insertion effect if you
want to apply a different reverb effect to a drum voice.
EFFECT
[Effect]Localizer RevSend ChoSend
off 40 40
Category
Parameter
1
2
3
[Reverb] Type Time Diffusion InitDlay
HALL1 2.1 10 12.7
1
