51
●
You can adjust the sensitivity of the hi-hat controller connected to the H.HAT CONTROL
jack.
➝
[FootCtrl1] Sens in Drum Kit Trigger Edit mode (page 38)
●
You can set the depth at which the hi-hat controller outputs a closed hi-hat signal and the
detection time for the foot splash.
➝
[UT7] FCoffset, FCspt in Utility mode (page 74)
●
You can set the hi-hat controller (foot controller) connected to the H.HAT CONTROL jack
to act as a MIDI controller.
➝
[FootCtrl1] Func, [FootCtrl2] MIDI, Type in Drum Kit Trigger Edit mode (page 38)
●
You can set the footswitch connected to the FOOT SW jack to act as one of the following:
To use it as a hi-hat controller
➝
[FootSW1] Func, Velocity in Drum Kit Trigger Edit mode (page 39)
To use it as a kick pedal
➝
[FootSW1] Func, Velocity in Drum Kit Trigger Edit mode (page 39)
To use it to select a drum kit, to start/stop a song, or so on.
➝
[FootSW1] Func in Drum Kit Trigger Edit mode (page 39)
To use it as a MIDI controller
➝
[FootSW1] Func, MIDI, Type, [FootSW2] OnValue, OffValue in Drum Kit Trigger Edit
mode (page 39)
●
You can set the DTXTREME to temporarily ignore trigger signals from the connected pads
and controllers.
➝
[UT6] TrgByps in Utility mode (page 73)
●
The above features can also be switched on/off via the pads.
➝
[TrgFunc] Func in Drum Kit Trigger Edit mode (page 29)
Drum Voice Settings
●
When using the Special Snare voice, you can choose shell and mute settings, adjust the
tension using the snappy settings and so on, just as with a real acoustic drum.
➝
[Voice2]
Special Snare settings page in Drum Kit Voice Edit mode (page 45)
●
You can set the key mode and alternate group voices that sound simultaneously.
➝
[Voice5] KeyMode, AltGrp in Drum Kit Voice Edit mode (page 47)
●
You can select whether or not to ignore Note On/Off messages for each MIDI Note
Number.
➝
[Voice5] RvKeyOn, RvKeyOff in Drum Kit Voice Edit mode (page 48)
●
You can set the total volume level for the whole drum kit.
➝
[COMMON1] Volume in Drum Kit Trigger Edit mode (page 40)
●
You can specify chords to play back using the pads.
➝
[Chord] in Drum Kit Trigger Edit mode (page 33)
●
You can set the crossfade, which controls the change in volume when multiple voices are
played back simultaneously.
➝
[TrgMIDI3] VelXFade in Drum Kit Trigger Edit mode (page 34)
