REFERENCE SECTION
Drum Kit T
rigger Edit Mode
28
[TrgSens2] Trigger Sense 2
Set the Level range and Velocity range for each
input. The Level range defines the maximum
and minimum input level. The Velocity range
defines the output range of the Velocity values
according to the Level range. Together, these
settings define how loud the sound is when the
pad is hit with a certain strength (input level).
1
Input=
Select the trigger input.
❏
Settings:
1 - 16
n
If the Learn parameter in the [UT 5] page in Utility
mode has been set to “always,” you can select the
trigger input by hitting the corresponding pad. See
page 73 for details of the Learn parameter.
2
Level
Set the maximum and minimum input levels for
each input. Velocity values are output according
to these settings. If the input signal exceeds the
maximum level set here, the maximum velocity
(as set in the Velocity parameter, explained
below) is output. If the input signal is below the
minimum level, no sound is output. When you
hit a pad, the input level is displayed as a
percentage to the right of the Level.
❏
Settings:
Minimum level: 0 - 99
Maximum level: 1- 100
n
See the following column for an explanation of the
relationship between input level and velocity.
3
Velocity
Set the maximum and minimum velocity values
for each input. These settings are used together
with the maximum and minimum Level settings
to determine how loud each sound is output.
When you hit a pad, the output velocity value is
displayed to the right of the Velocity. If, for
example, you set a high minimum velocity, the
sound will be loud even if you hit the pad gently.
Note, however, that this will reduce the dynamic
range and therefore the expressiveness of the
sound.
n
See the following column for an explanation of the
relationship between input level and velocity.
❏
Settings:
Minimum velocity: 0- 126
Maximum velocity: 1 - 127
Relationship Between Velocity Curve,
Input Level and Velocity
Ex. 1
In this illustration, velocity values are
output for input levels between 12% and
99%. For an input level of 12%, the
velocity is 001. For an input level of 99%,
the velocity is 127.
Ex. 2
In this illustration, velocity values are
output for input levels between 50% and
99%. For an input level of 50%, the velocity
is 064. For an input level of 99%, the
velocity is 127. No sound is produced with
the “0” velocity value that is output by
input levels between 00% and 49%.
[TrgSens2] Level(100%) Velocity(127)
Input=16 20% to 100% 32 to 127
Minimum
level
Input level (%)
Maximum
level
Minimum
velocity
Maximum
velocity
Input velocity
2
3
1
velocity
127
001
99%
12%
velocity
127
064
001
99%
50%
0 - 49%
No sound is output
Summary of Contents for DTXTREME
Page 1: ......
