REFERENCE SECTION
Drum Kit T
rigger Edit Mode
41
[COMMON2] Common 2
Set the song and tempo settings used when you
select the current drum kit.
1
Song
Specify the song that is loaded when you select
the current drum kit. Set this to “off” to disable
the selection of a song when selecting the current
drum kit.
❏
Settings:
off, P1 - P31 (demo songs), Q1 - Q67 (practice
songs), R1 - R66 (pad songs), U1 - U32 (user
songs), C1 - C99 (card songs)
2
Tempo
Specify the tempo that is set when you select the
current drum kit. Set this to “off” to disable the
selection of a tempo when selecting the current
drum kit.
❏
Settings:
off, 30 - 300
3
9to10
Trigger inputs 9 and 10 accept two separate pad
outputs using a single stereo jack. If you set this
to “on,” a signal on input 9 will be reproduced
on input 10.
❏
Settings:
off, on
4
11to12
Trigger inputs 11 and 12 accept two separate pad
outputs using a single stereo jack. If you set this
to “on,” a signal on input 11 will be reproduced
on input 12.
❏
Settings:
off, on
[KitName] Kit Name
Enter a name consisting of up to 8 characters for
the current drum kit.
1.
Use the Data Control knob assigned to
←
→
(cursor) to move the cursor to the drum kit
name’s first character position. Then use the
center Data Control knob to enter a character
at that position.
2.
Move the cursor to the next character position
and enter a character here.
3.
Repeat steps 1 and 2 above until you enter a
maximum of 8 chracters for the drum kit
name.
❏
Acceptable characters:
[COMMON2] Song Tempo 9to10 11to12
P1 off off off
1
4
3
2
[KitName] Name "Acoustic"
<90abc>
! " # $ % & ’ ( ) *
,
. / 0 1 2 3
4 5 6 7 8 9 : ; <
> ? @ A B C D E F G
H I J K L M N O P Q R S T U V
X Y Z [
¥ ] ^ _
`
a b c d e f g h i j k l m n o
p q r s t u v w x y z { | }
← →
=
W
+
-
Summary of Contents for DTXTREME
Page 1: ......
