REFERENCE SECTION
Utility Mode
70
Utility Mode
The DTXTREME system settings are made in this
mode, and includes parameters that are common
to all modes such as MIDI, effects and Memory
Card settings.
Entering Utility Mode
Press the UTILITY button.
Edit Pages and Basic
Operations in Utility Mode
The Utility mode parameters are grouped into the
following seven categories. Each category has its
own parameters pages.
1.
Use the Page
▲
and
▼
buttons to select the
Page containing the parameter you wish to
set. The Page
▲
and
▼
buttons let you select
any page regardless of category.
2.
Use the leftmost Data Control knob and jump
to the first page of each category. The first
page of each category are: [UT 1], [UT 3], [UT
5], [UT 9], [UT 13], [UT 17] and [UT 19].
3.
Use the Data Control knob below each
parameter to change the parameter’s value. In
Utility mode, the values are stored as you
enter them (no Store operation required).
n
By turning the knobs while holding down the SHIFT
button, the values will change in larger increments.
Utility Mode
——
Master EQ (Master Equalizer) (page 71)
3Band Master EQ settings
——[UT 1] Master EQ 1
——[UT 2] Master EQ 2
——
TG (Tone Generator) (page 71)
Tone generator settings.
——[UT 3] TG 1
——[UT 4] TG 2
——
SYSTEM (page 72)
System settings
——[UT 5] SYSTEM 1
——[UT 6] SYSTEM 2
——[UT 7] SYSTEM 3
——[UT 8] SYSTEM 4
——
MIDI (page 75)
MIDI settings
——[UT 9] MIDI 1
——[UT 10] MIDI 2
——[UT 11] MIDI 3
——[UT 12] MIDI 4
——
CLICK (page 77)
Click sound and mode settings
——[UT 13] CLICK 1
——[UT 14] CLICK 2
——[UT 15] CLICK 3
——[UT 16] CLICK 4
——
SEQ (Sequencer) (page 79)
Sequencer settings
——[UT 17] SEQ 1
——[UT 18] SEQ 2
——
CARD (page 80)
Memory Card-related operations
——[UT 19] CARD LOAD
——[UT 20] CARD SAVE
——[UT 21] CARD DELETE
——[UT 22] CARD RENAME
——[UT 23] CARD FORMAT
[UT 1] Low(Freq Gain) Mid(Freq Gain)
EQ 100Hz + 0 800Hz + 0
UTILITY
[UT 1] Low(Freq Gain) Mid(Freq Gain)
EQ 100Hz + 0 800Hz 0
Category display
Parameter
Summary of Contents for DTXTREME
Page 1: ......