REFERENCE SECTION
Utility Mode
75
[UT 8] SYSTEM 4
In this page, you can return the DTXTREME’s
settings to their factory defaults.
Factory Set
The factory default values for all the unit’s
settings are restored.
Factory Set (Factory Default Settings)
The DTXTREME’s drum kits, effects, trigger
settings and other settings have default
values as the unit is shipped from the
factory. As you edit these settings, the
default values are overwritten. If necessary,
you can restore the DTXTREME’s settings
to their default values as explained below.
When you restore the factory defaults,
all current settings will be overwritten
and lost. Make sure you will not be
overwriting important data. It is
recommended that you back up
important data to Memory Card or
some other external storage medium
beforehand.
1.
In Utility mode, select the [UT 8] page
(4th page under SYSTEM). Press the
ENTER/YES button and you will see an
“Are you sure?” message.
2.
Press the ENTER/YES button again and
the factory defaults will be restored. If
you press the EXIT/NO button instead,
the defaults will not be restored and you
will be returned to Drum Kit Play mode.
MIDI
Set the DTXTREME’s MIDI-related settings here.
[UT 9] MIDI 1
Set the Bulk Dump settings on this page. The
available parameters are as follows.
Transmit Bulk Data
You can select and sent various types of Bulk
Dump data to, say, a Yamaha MDF3 MIDI Data
Filer or an external MIDI sequencer that can
handle system exclusive messages.
all data:
All DTXTREME data is sent.
system:
The DTXTREME system data is sent.
cur DKIT:
Data for the current drum kit is sent.
all DKIT:
Data for all drum kits is sent.
curCHAIN:
The current chain data is sent.
allCHAIN:
All chain data is sent.
cur SONG:
Data for the current song is sent.
all SONG:
Data for all songs is sent.
❏
Settings:
all data, system, cur DKIT, all DKIT, curCHAIN,
allCHAIN, cur SONG, all SONG
Performing Bulk Dump
1.
In Utility mode, select the [UT 9] page
(1st MIDI page) showing Transmit Bulk
Data.
2.
Select the type of data you wish to
transmit. Press the ENTER/YES button
and you will see an “Are you sure?”
message.
3.
Press the ENTER/YES button again and
the bulk dump will proceed. If you
press the EXIT/NO button instead, the
bulk dump will not proceed and you
will be returned to Drum Kit Play mode.
[UT 8] Factory Set
SYSTEM
[UT 8] Factory Set
Are You Sure ? [Yes/No]
ENTER
YES
ENTER
YES
[UT 9] Transmit Bulk Data
MIDI all data
Summary of Contents for DTXTREME
Page 1: ......