REFERENCE SECTION
Utility Mode
76
Receiving Bulk Data
Send out the DTXTREME bulk data stored
on an external MIDI device such as
Yamaha MDF3 MIDI Data filer or MIDI
sequencer. Since the DTXTREME can
receive incoming bulk data in any mode,
no special preparation to receiving bulk
data is required. When the DTXTREME start
receiving incoming bulk data, it shows the
following display.
When bulk loading process is finished, the
DTXTREME shows the following display
for a few seconds and shows the previous
display.
n
To receive incoming bulk data, the
DTXTREME must have a matched device
number to the sending MIDI device.
[UT 10] MIDI 2
At this page, you can set bulk dump-related
settings and select the MIDI operation mode. The
available parameters are as follows.
1
Dev.No
Set the MIDI device number. This number has to
be the same as that of the other external MIDI
device when transfering system exclusive data
(such as bulk data or parameter changes)
between the DTXTREME and such a device.
❏
Settings:
all, 1 - 16
2
DumpIntrvl
Set the interval time between packets sent via
bulk dump. When sending to older or less
powerful devices, it may be useful to set this to a
high value.
❏
Settings:
50, 100, 150, 200, 250, 300 (unit: milli second)
3
MIDImode
Set the MIDI operation mode. You can set how
the DTXTREME responds to Program Change
messages from an external MIDI device.
native:
Program Change messages will select
regular DTXTREME drum kits.
GM:
Program Change messages will select GM-
type drum kits.
❏
Settings:
native, GM
[UT 11] MIDI 3
In this page, you can set the parameters for MIDI
messages received by the DTXTREME’s internal
tone generator.
1
Receive10
Select whether or not to receive MIDI channel
messages on channel 10.
❏
Settings:
off, on
2
PC
Enable or disable the reception of Program
Change messages. When enabled, the internal
tone generator receives MIDI Program Change
messages sent from the controller portion of the
DTXTREME or an external MIDI device and
switch between drum kits, keyboard sounds and
so on.
❏
Settings:
off, on
Receiving Bulk data. in progress.
Receiving Bulk data. completed.
[UT 10] Dev.No DumpInterval MIDImode
MIDI 16 150 native
1
2
3
[UT 11] Receive10 PC PC10 SysEx
MIDI on on on on
1
2
3
4
Summary of Contents for DTXTREME
Page 1: ......