16
Rotatable Horn
When shipped from the factory, the directi
v
ity of DZR(-D) series speaker in a
v
ertical orientation is the setting
w
hich
makes the so
u
nd expand in a horizontal direction, and inhi
b
its or narro
w
s the so
u
nd in a
v
ertical direction. We rec-
ommend changing the directi
v
ity
b
y rotating the horn
w
hen yo
u
w
ant to install the DZR(-D) series speaker horizon-
tally or
w
hen yo
u
w
ant to
u
se them as a floor monitor and
b
roaden the directi
v
ity.
1.
Using a 2.5 mm hexagonal wrench, remove all fixing screws (DZR10(-D): six total) on the grille, and remove the grille from
the speaker.
2.
Using a No. 2 Phillips head screwdriver, remove all screws installed on the horn and pull the horn out from the speaker.
3.
Rotate the horn 90 degrees, and re-install the horn to the speaker, reversing the steps above.
• Make sure not to push the screws too strongly with the Phillips head screwdriver. This may cause the nuts inside the cabinet to fall off.
• If the horn cannot smoothly be pulled out, hook the notches using a flat-bladed screwdriver, and pull out.
Full ran
g
e: DZR15(-D), DZR12(-D), and DZR10(-D)
NOTE
Screws (eight total)
Notch
Vertical
Rotate 90°
Horizontal
Summary of Contents for DZR315
Page 29: ...160...
