36
ENGLISH
TROUBLESHOOTING
TROUBLESHOOTING
3
CAUTION:
To avoid personal injury:
¡
Always perform all checks with engine stopped and cool to the touch except for
those checks in which operation is required.
¡
DO NOT touch the charging section during operation.
¡
Avoid any contact with rotating fan during operation.
If the engine does not function properly, use the following chart to identify and correct the cause.
Generator Troubleshooting
Trouble
Possible causes
Correction
Unusual noise or
vibration
Single-phase load applied beyond allowable
level (on three phase models).
*Lower the load to acceptable level.
Bearing deteriorated.
*Replace the bearing.
Coupling damaged.
*Replace the coupling.
Frame overheated.
Cooling fan inlet or outlet blocked.
*Unblock the inlet or outlet.
Voltage too high.
*Readjust the voltage.
Overloaded.
*Reduce the load.
Voltage failure to rise.
Voltage maladjusted.
*Readjust using the voltage control.
AVR excitation output cable broken.
*Repair the cable.
AVR itself in trouble.
*Replace the AVR.
Exciter's winding short-circuited or broken.
*Replace the generator.
AVR excitation input cable broken.
*Repair the cable.
Generator's winding broken.
*Replace the generator.
AVR excitation output fuse blown out.
*Replace the fuse.
Voltage too high.
Voltage maladjusted.
*Readjust using the voltage control.
AVR voltage detection cable broken.
*Repair the cable.
AVR itself in trouble.
*Replace the AVR.
Mercury arc lamp or such conductive load connected.
*Disconnect such load.
Voltage hunting
Pilot lamp failure to
light up
Inverter or such switching load connected.
*Disconnect such load.
AVR itself in trouble.
*Replace the AVR.
Circuit breaker turned
OFF.
Connected cable or load short-circuited.
*Contact a qualified electrical
engineer for inspection.
Overloaded.
Lamp bulb broken.
Generator voltage too low.
*Reduce the load.
*Replace the bulb.
*See "Voltage failure to rise" above.
WARNING
9CGNO̲E̲p00-40.indd 52
9CGNO̲E̲p00-40.indd 52
2009/12/18 16:56:52
2009/12/18 16:56:52
Summary of Contents for EDL13000SDE
