Connections
13
ELS-01/01C Owner’s Manual
221
When you connect your Electone with a second MIDI device (such as a synthesizer or
computer), you can determine how the Electone controls that MIDI device, or how the
Electone is controlled.
Press the [UTILITY] button in the panel to call up the Utility
Display.
Press the [MIDI] button at the top right of the display to call up
the MIDI Page.
1
OUTPUT
For setting the channels over which MIDI information will be transmitted. Any
channel from 1 through 16 can be assigned to each keyboard (the Upper keyboard, the
Lower keyboard and the Pedalboard) as well as the Expression pedal and 2nd
Expression pedal. The MIDI messages for each keyboard and Expression pedal will be
sent on the channels set here. You must set the transmit channel here to match the
receive channel of the connected device. (The ELS-01 does not show the 2nd
Expression pedal.)
Pressing each OUTPUT button calls up the channel selection pop-up menu. After you
select the desired channel, the pop-up menu automatically closes.
The Expression pedal and 2nd Expression pedal can be set to “OFF” (MIDI
information will not be transmitted). On the 2nd Expression pedal, CC#4 by which
MIDI information is output as Second Expression can be also set.
2
MIDI OUT FILTER
Deletes unnecessary MIDI data and keeps it from being transmitted from the Electone.
After Touch and Rhythm start/stop are automatically filtered on the ELS-01.
In addition, Horizontal Touch and Second Expression are automatically filtered on the
ELS-01C. Set the parameter for which you wish to disable transmission to ON.
5
MIDI Control
1
2
1
2
3
3
-1
3
-2
3
-3
NOTE
If you set Second Expression
to on in the MIDI OUT FILTER
parameters, the setting in the
OUTPUT (
1
) parameters will
be disabled.
