Yamaha EMX62M, Owner'S Manual

Front & Rear Panels

11

EMX62M—Owner’s Manual

M

Peak level indicator

This indicator indicates the level of the signal 
output from the MAIN OUTPUT jack (input/
output panel 

9

). Adjust the MASTER control 

B

so that this indicator lights up only momentarily 
to avoid distortion.

N

LIMITER indicator

The LIMITER indicator lights up when the lim-
iter circuit, which is designed to protect the inter-
nal power amplifier against excessive input 
signals and load mismatches, activates.

■

MONITOR Section

The MONITOR section is used to set the MONI-
TOR MASTER level and MONITOR EFFECT 
RTN level.

O

EFFECT RTN control

The MONITOR EFFECT RTN control deter-
mines the level of the signal from the built-in dig-
ital effects processor that is fed to the MONITOR 
bus and subsequently the MONITOR OUTPUT.

P

MASTER control

The MONITOR MASTER control determines the 
output level of the MONITOR OUTPUT.

■

PHANTOM switch and indicator

Q

PHANTOM switch and indicator

This switch turns the phantom power supply on/
off for the Low-Z input jacks of channels 1–4. 
When the switch is turned on, the indicator lights 
up.

Turn this switch off if you do not use it.

■

YAMAHA SPEAKER PROCESSING

R

ON/OFF switch

This switch enables you to compensate the low 
range of the speakers. The low range balance 
when this switch is on varies depending on the 
speakers. 

First, check the low range balance by auditioning 
the resultant sound, then set this switch to on or 
off.

■

Power switch and indicator

S

Power ON/OFF switch and indicator

This switch turns the power of the EMX62M on/
off. When the switch is turned on, the indicator 
lights up.

Note:   Do not let the LIMITER indicator light 
up or flash for a long period of time. Otherwise, 
the power amplifier would be under excessive 
loads, which might lead to a malfunction of the 
unit.

E

F

Note:   Before turning the EMX62M on/off, turn 
down the MASTER controls of the MONITOR 
and MAIN section.

G

H

I