Quick Start Guide
11
EMX7 Owner’s Manual
Using the Built-in Effects
It is possible to add effects that simulate the sound of different performance environments, such
as concert halls and small clubs.
1.
Call up the HOME screen.
When the [
] (Power) switch is turned on (
), the HOME
screen is displayed. (See the figure to the right.) If a different
screen is displayed, it will come up as soon as the [PROGRAM]
rotary encoder is operated.
2.
Use the [PROGRAM] rotary encoder to select the desired effect.
q
Turn the [PROGRAM] rotary encoder to select the program.
w
Press the [PROGRAM] rotary encoder to confirm your selection.
e
Once confirmed, the background and number colors will be highlighted.
3.
Turn on (
) the FX RTN [FX ON] switch.
The switch lights up to indicate that it is on. Connect a control device such as the optional FC5 foot switch (sold separately)
to the [FOOT SW] jack, which lets you conveniently bypass/enable the built-in effects.
4.
Set the FX RTN [LEVEL] control to the [
] position.
5.
Use the [AUX2/FX] send controls to adjust the effect depth for each channel you wish to apply
the effect.
6.
Use the FX RTN [LEVEL] control to adjust the overall effect depth.
If you wish to change effect parameters such as reverb time or delay time, adjust the FX RTN [PARAMETER] control. (See
section
!2
on page 12.) For details about the parameters of each effect that can be adjusted with the FX RTN [PARAME-
TER] control, refer to the “Effect Programs” on page 25.
Program number
Program name
NOTE
• For details about available effects, refer to the “Effect Programs” on page 25.
• If no operation is detected for an extended period of time, and the selected program is not confirmed, the system will
automatically return to the previously confirmed program.
t
