When the unit is turned off, video and/or
audio from a playback device are not
output to the TV
z
z
7KH+'0,FRQWUROIXQFWLRQLVGLVDEOHG
Enable the HDMI control function. For details, see the following:
– “Configuring the HDMI control function” (p.37)
The unit cannot be operated using the
remote control
z
7KHXQLWLVRXWRIWKHRSHUDWLQJUDQJH
Use the remote control within the operating range. For details,
see the following:
– “Operating range of the remote control” (p.17)
z
7KHEDWWHULHVDUHZHDN
Replace with new batteries. For details, see the following:
– “Replacing the battery in the remote control” (p.17)
z
7KHUHPRWHFRQWUROVHQVRURIWKHXQLWLVH[SRVHGWRGLUHFW
VXQOLJKWRUVWURQJOLJKWLQJ
Adjust the lighting angle, or reposition the unit.
The TV cannot be operated using the TV’s
remote control
z
7KHXQLWLVEORFNLQJWKH79nVUHPRWHFRQWUROVHQVRU
Position the unit so that it does not obstruct the TV’s remote
control sensor.
The unit cannot be operated using the
TV’s remote control
z
7KH+'0,FRQWUROIXQFWLRQLVLQFRUUHFW
Confirm the settings are properly configured as follows.
– The HDMI control function of the unit is enabled.
– The HDMI control function is enabled on the TV.
– Set audio output to any option other than TV.
If the unit cannot be operated with the TV's remote control, even
after the settings have been applied correctly:
– Turn off the unit and the TV, and then turn them back on
again.
– Disconnect the power cord of the unit and external devices
connected to the unit via HDMI cable. Plug them in again after
about 30 seconds.
z
7KH79DQG%''9'SOD\HUDUHQRWIURPWKHVDPH
PDQXIDFWXUHU
We suggest using devices such as a TV and BD/DVD player
from the same manufacturer.
z
7KH79GRHVQRWVXSSRUWWKHXQLWnVIXQFWLRQV
Even if your TV supports the HDMI control function, some
functions may not be available. For details, refer to
documentation supplied with your TV.
En
43
