Operation
35
●
Use the power tilt switch located on the
bottom engine cowling (if equipped)
only when the boat is at a complete stop
with the engine off.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
To raise the bow (trim-out), press the switch
“
” (up).
To lower the bow (trim-in), press the switch
“
” (down).
Make test runs with the trim set to different an-
gles to find the position that works best for
your boat and operating conditions.
NOTE:
To adjust the trim angle while the boat is mov-
ing, use the power trim and tilt switch located
on the remote control device or tiller handle, if
equipped.
EMU27910
Adjusting boat trim
When the boat is on plane, a bow-up attitude
results in less drag, greater stability and effi-
ciency. This is generally when the keel line of
the boat is up about 3 to 5 degrees. With the
bow up, the boat may have a greater tenden-
cy to steer to one side or the other. Compen-
sate for this as you steer. The trim tab can
also be adjusted to help offset this effect.
When the bow of the boat is down, it is easier
to accelerate from a standing start onto plane.
Bow Up
Too much trim-out puts the bow of the boat
too high in the water. Performance and econ-
omy are decreased because the hull of the
boat is pushing the water and there is more air
drag. Excessive trim-out can also cause the
propeller to ventilate, which reduces perfor-
mance further, and the boat may “porpoise”
(hop in the water), which could throw the op-
erator and passengers overboard.
1. Power trim and tilt switch
1. Power trim and tilt switch
63P10.book Page 35 Tuesday, May 13, 2003 10:23 AM
Summary of Contents for F150C
