5-9
E
EMU01511
TREATMENT OF SUBMERGED
MOTOR
If the outboard motor is submerged, immedi-
ately take it a Yamaha dealer. Otherwise,
some corrosion may begin almost immedi-
ately.
If you cannot immediately take the outboard
motor to a Yamaha dealer, follow the proce-
dure below in order to minimize engine dam-
age.
EMU00448
1) Thoroughly wash away mud, salt, sea-
weed, etc. with fresh water.
2) Remove the spark plug(s), then face the
spark plug holes downward to allow any
water, mud or contaminants to drain.
3) Drain the fuel from the carburetor, fuel
filter and fuel line. Drain the engine oil
completely.
4) Fill the sump with the fresh engine oil as
the same quantity as the engine oil
capacity.
5) Feed engine fogging oil or engine oil
through the carburetor(s) and spark plug
hole(s) while cranking the engine with
the manual starter or emergency starter
rope.
6) Take the outboard motor to a Yamaha
dealer as soon as possible.
CAUTION:
@
Do not attempt to run the motor until it
has been completely inspected.
@
Engine oil capacity:
Refer to SPECIFICATIONS, Page 4-1.
U68T15.book Page 9 Thursday, March 20, 2003 11:28 AM
Summary of Contents for F6C
