Instrument an
d
control functions
4-12
4
In this case, push the select switch to
switch the display in the following or-
der;
TRIP-F
→
Display–1
→
Display–2
→
Display–3
→
TRIP-F
To reset a tripmeter, use the select
switch to select the information display
that contains the tripmeter you want to
reset. Push the “RESET” button briefly
so that the tripmeter flashes, and then
push the “RESET” button again for 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally after refueling and traveling 5 km
(3 mi).
Estimated traveling range display:
The distance that can be traveled with
the remaining fuel in the fuel tank under
the current riding conditions is shown.
Elapsed time display:
The time that has elapsed since the key
was turned to “ON” is shown. The
maximum time that can be shown is
99:59.
This timer automatically resets when
the key is turned to “OFF”.
TIP
There are also “TIME–2” and “TIME–3”
elapsed time displays, but they cannot
be set to the information display. See
“Setting mode” on page 4-14 for de-
tailed information.
Ambient temperature display:
This display shows the ambient tem-
perature from 16 °F to 122 °F in 1 °F in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
16 °F will be displayed even if the
ambient temperature falls below
16 °F.
122 °F will be displayed even if the
ambient temperature climbs
above 122 °F.
The accuracy of the temperature
reading may be affected when rid-
ing under 20 km/h (12 mi/h) or
when stopped at traffic signals
and railroad crossings.
Coolant temperature display:
The coolant temperature display indi-
cates the temperature of the coolant.
The coolant temperature varies with
changes in the weather and engine
load.
27
RANGE
mile
0:06
TIME TRIP
77
A.TEMP
˚F
Lo
C.TEMP
˚F
UB9614E0.book Page 12 Friday, November 15, 2019 1:30 PM
