STEP #1
Hole in #1 strap sandwiches in hatch.
Loosen bolt in photo, slide strap in between
plastic and align hole with bolt. Re-fasten
bolt. Close hatch, with strap dangling, place
bracket parallel with the hatch. Using the
brackets, mark holes where drilling is
needed. Drill holes, attach rivets and repeat
for opposite side.
STEP #2
Align the #2 strap by placing the strap
over the glove box. Align ends that will be
riveted with trim on each side. Using strap
mark holes where drilling is needed. Drill
holes, attach rivets and repeat for opposite
side.
STEP #3
Align the # strap (with handle) on the rear
of the front seat. Level bracket, using
bracket mark holes where drilling is
needed. Drill holes, attach rivets and
repeat for opposite side.
STEP #4
Align the #4 strap on the rear of the rear
seat. Using strap, mark holes where
drilling is needed. Drill holes, attach rivets
and repeat for opposite side.
