Instrument operation
40
EJU42241
Multifunction information
center
The multifunction information center displays
various watercraft information.
Multifunction information center initial op-
eration
When the multifunction information center is
activated, the analog speedometer/tachome-
ter makes one sweep, and all of the display
segments and indicator lights come on. After
2 seconds, the “WARNING” indicator light
and the warning indicators in the information
display go off, and then the center starts to
operate normally.
TIP:
The “UNLOCK” indicator light will go off
when the engine is started.
Multifunction information center standby
state
If the multifunction information center does
not receive any operation input within 25 sec-
onds after the engine stops, the center will
turn off and enter a standby state. When the
engine is started again, the displays return to
their state before the center turned off, and
then the center starts to operate normally.
EJU42331
Analog speedometer/tachometer
The analog speedometer/tachometer has
both a speedometer function and a tachom-
eter function. By switching the meter, it can
be used as either a speedometer or a ta-
chometer.
TIP:
The analog tachometer is selected at the
Yamaha factory.
Analog tachometer
The analog tachometer shows the engine
speed.
1
Information display
2
“UNLOCK” indicator light
3
Analog speedometer/tachometer
4
“WARNING” indicator light
5
“L-MODE” indicator light
6
Multifunction display
7
“RPM” indicator light
8
“SPEED” indicator light
1
“SPEED/RPM” button
2
“VOLT/HOUR” button
3
“START/STOP” button
4
“MODE/RESET” button
6
1
3 4
8
7
2
5
1
2
3
4
UF2T75E0.book Page 40 Thursday, May 21, 2015 9:30 AM
