53
English
ADDITIONAL
INFORMA
TION
Problem
A “humming” sound
can be heard.
The volume level
cannot be increased,
or the sound is
distorted.
The sound effect
cannot be recorded.
The sound field
parameters and some
other settings on this
unit cannot be
changed.
This unit does not
operate properly.
“CHECK SP WIRES”
appears on the front
panel display.
There is noise
interference from
digital or high-
frequency equipment,
or this unit.
This unit suddenly
turns into the standby
mode.
Cause
Incorrect cable connections.
The component connected to the OUT
(REC) jacks of this unit is turned off.
It is not possible to record the sound
effect by a recording component.
“10 MEM. GUARD” in the SET
MENU is set to ON.
The internal microcomputer has been
frozen by an external electric shock
(such as lightning or excessive static
electricity) or by a power supply with
low voltage.
Speaker cables are short circuited.
This unit is too close to the digital or
high-frequency equipment.
The internal temperature becomes too
high and the overheat protection
circuitry has been activated.
Remedy
Firmly connect the audio plugs. If the problem
persists, the cables may be defective.
Turn on the power to the component.
Set “10 MEM. GUARD” in the SET MENU
to OFF.
Disconnect the AC power cord from the outlet
and then plug it in again after about 30 sec-
onds.
Make sure all speaker cables are connected
correctly.
Move this unit further away from such
equipment.
Wait until this unit cools down and then turn it
back on.
Refer to
page
10 – 16
—
—
—
—
—
—
—
TROUBLESHOOTING
0110HTR5635_51-57_EN.p65
02.12.12, 6:55 PM
53