7
ENGLISH
FRANÇAIS
DEUTSCH
SVENSKA
ITALIANO
ESPAÑOL
DUTCH
¤
30 dB
–
A
NORM
‹
R
L
20
15
10
8
6
4
2
0
2
4
6 +
¤
B
‹
RELAY
DUB
HIGH
REC
B C
DOLBY NR selector setting (in step 2)
Be sure to set the DOLBY NR selector according to the
system used for recording.
OFF: For a tape recorded with DOLBY NR OFF.
B: For a tape recorded with DOLBY B NR.
C: For a tape recorded with DOLBY C NR.
REVERSE MODE selector setting (in step 3)
The auto reverse function allows the tape running direction
be reversed automatically. Select an auto reverse mode
(
,
, or
RELAY
) or manual reverse mode
(
).
: When playback or fast forwarding (or rewinding) of
one side of a tape is finished, the deck stops at the
end of the tape.
: Both sides of the tape are played back. After
playing, the deck stops at the end of the tape.
(When the tape running direction is set to
¤
, only
the reverse side is played.) When the tape is fast
rewound to the beginning of the reverse side,
playback automatically starts from the same side.
When the tape is fast forwarded to the end of the
forward side, playback automatically starts from the
reverse side.
: Both sides of the tape are repeatedly played back
(up to 8 times).
When the tape is fast forwarded or rewound to the
beginning or the end of a side, playback
automatically starts from the same side or the other
side respectively.
RELAY
: Cassette tapes loaded in DECKs A and B
are played back sequentially. (See “RELAY
PLAYBACK” on page 9.)
To adjust the volume level
Use the volume control of the amplifier or receiver.
To use headphones
Insert the headphones plug into the PHONES jack. Since
the sound is also heard from the speakers, operate the
amplifier to cut off the sound from the speakers for private
listening.
Note
Never press the EJECT button during playback.
Display during playback
Tape running direction
indicator (DECK A)
Tape running direction
indicator (DECK B)
Tape counter
Tape counter
Peak level meters
Indicate the peaks of the signal levels during recording and playback over a –30 dB to +6 dB range. There are separate meters for each left
and right channel. These level meters have a peak hold function which holds the peak level for about 1.5 seconds.
