Playing CDs
Getting Started
OPERATIONS
E-9
English
4
Press
)
to close the tape tray.
5
Press DOLBY NR to set the DOLBY NR function to
ON (DOLBY NR indicator lights up) or OFF
(DOLBY NR indicator goes out).
OFF: For recording with DOLBY NR OFF.
ON: For recording with DOLBY NR ON.
6
Press MODE to select the reverse mode.
Each time you press MODE, the reverse mode
changes and the corresponding MODE indicator
lights up as follows:
: One side of the tape is recorded.
,
: Both sides of the tape are recorded.
7
Press REC/PAUSE.
The unit stands by for recording and the REC
indicator flashes.
8
Press
3
.
Recording starts and the tape direction indicator
3
lights up.
If you want to record starting from the bottom side,
press
2
so that the tape direction indicator
2
lights
up.
9
Start playing on the source component.
To stop recording
Press
7
.
To pause recording
Press REC/PAUSE.
To resume recording, press REC/PAUSE again.
Note
• When you want to reduce the hiss noise in low-level high-
frequency signals, set DOLBY NR to ON.
• When you record on the bottom side of the tape, the unit
stops recording after complete recording the bottom side of
the tape regardless of the reverse mode setting in step 6
above.
To insert a blank space during
recording
Press REC MUTE during recording or Rec/Pause
mode.
A 4 seconds blank interval is automatically recorded on
the tape and then the unit enters Rec/Pause mode.
To resume recording, press REC/PAUSE.
