[Description]
Uses the CoS value of the VLAN tag header as the condition to classify the traffic class.
If this is executed with the "no" syntax, the CoS condition setting is deleted.
The setting can be repeated up to the maximum number (eight) of registrations.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Specify CoS values "1" and "2" as the classification conditions for class map "class1."
SWR2311P(config)#class-map class1
SWR2311P(config-cmap)#match cos 1 2
9.2.15 Set traffic classification conditions (TOS precedence)
[Syntax]
match
ip-precedence
tos-list
no
match
ip-precedence
[Parameter]
tos-list
:
<0 - 7>
Value of the IP header's TOS precedence field used as a classification condition. Up to eight can be
registered.
[Input mode]
class map mode
[Description]
Uses the value of the IP header's TOS precedence field as a condition to classify the traffic class.
If this is executed with the "no" syntax, the classification conditions using TOS precedence are deleted.
The setting can be repeated up to the maximum number (eight) of registrations.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Specify TOS precedence values "3" and "4" as the classification conditions for class map "class1".
SWR2311P(config)#class-map class1
SWR2311P(config-cmap)#match ip-precedence 3 4
9.2.16 Set traffic classification conditions (DSCP)
[Syntax]
match
ip-dscp
dscp-list
no
match
ip-dscp
[Parameter]
dscp-list
:
<0 - 63>
Value of the IP header's DSCP (DiffServ Code Point) field used as a classification condition. Up to
eight can be registered.
[Input mode]
class map mode
[Description]
Uses the value of the IP header's DSCP (DiffServ Code Point) field as a condition to classify the traffic class.
If this is executed with the "no" syntax, the classification conditions using DSCP precedence are deleted.
The setting can be repeated up to the maximum number (eight) of registrations.
[Note]
In order to execute this command, QoS must be enabled.
236
| Command Reference | Traffic control
