8
ME02R96
ENGLISH
Reattach the Control Panel
1.
Lower the control panel back into place. Then refasten with the original screws, in the following
order: front panel first, then the sides, and then the rear. When fastening each panel, always
fasten the positioning screw first (see illustrations on page 6 above).
2.
If applicable:
Reinstall the MB02R96 peak meter bridge and/or the SP02R96 side panels by
reversing the removal procedures given on page 4 and 5 above.
●
Restoring the Saved 02R96 Data
If you saved the 02R96 data to an external MIDI device as described on page 3 above, you can now
restore that data as follows.
1.
After completing the kit installation, turn on the 02R96 power. The start-up screen displays the
message
MEMORY EXPANDED
.
2.
Press the DISPLAY ACCESS [MIDI] key to open the Bulk Dump page.
3.
Set the CATEGORY to ALL, select the REQUEST button, and then press the [ENTER] key.
●
Kit Contents
European models
Purchaser/User Information specified in EN55103-1 and EN55103-2.
Conforms to Environments: E1, E2, E3 and E4
Before screwing in the control panel, check to make sure that you have not left any loose screws or
tools inside the 02R96 casing. Loose objects left in the casing may cause damage to the equipment.
It is not possible to load automix data that exceeds the mixer’s automix memory capacity (7MB with
the ME02R96 installed; 1MB if it is not installed). If you attempt to load such data, the 02R96 will dis-
play an appropriate message and will execute the load. Any data already existing in the 02R96 will
remain unchanged.
ME02R96 Expansion Board
Lithium battery
4 Screws
ME02R96 Owner’s Manual (this booklet)
CD-ROM (Studio Manager)
Yamaha Manual Library
http://www2.yamaha.co.jp/manual/english/