Connections
74
MM6/MM8 Owner’s Manual
Since the MM6/MM8 has no built-in speakers, it must be connected to an external amplifier and speakers,
headphones, or other sound output device.
■
Connecting to Powered Speakers or Monitor Speakers.
● ● ● ● ● ● ● ● ● ● ● ● ● ●
For optimum, accurate reproduction of the instrument’s rich sounds with effects and full stereo imaging,
use a pair of powered speakers. Connect the powered speakers to the OUTPUT L/MONO and R jacks on
the rear panel.
■
Controlling an External Tone Module
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
This type of connection lets you play an external MIDI tone generator (tone generator module, etc.) from
the MM6/MM8 keyboard, or by playing back the MM6/MM8 songs or patterns.
Use this connection when you want the external instrument to sound as well as the MM6/MM8.
In order to play the external tone module in this type of setup, the MIDI receive channel of the tone module
must be set to the same channel as the MM6/MM8 MIDI transmit channel.
The MM6/MM8 transmit channels are fixed, as shown below.
Connecting to External Audio Equipment
PHONES jack
OUTPUT L/MONO jack
OUTPUT R jack
Keyboard amplifier, monitor speaker, etc.
Headphones
• When using just one powered speaker, connect it to the OUTPUT L/MONO jack on the rear panel.
NOTE
Connecting to External MIDI Devices
• MIDI data can be received and transmitted via the MIDI connectors as well as the USB TO HOST terminal.
However, they cannot be used at the same time.
NOTE
MIDI OUT Connector
MIDI IN Connector
MM6/MM8
Tone Module
Main Voice
Channel 1
Dual Voice
Channel 2
Split Voice
Channel 3
Summary of Contents for MM8
Page 1: ...EN Owner s Manual...
