3. Location and Connections
12
MMP1 Getting Started
3. Location and
Connections
3-1. Connection example
3-2. Before connecting
Make various settings of the unit in advance.
3-2-1. UNIT ID
3-2-2. How to connect to the Dante network
3-2-3. IP address
3-2-1. UNIT ID
Determines the ID for identifying each device on the
Dante network. For this setting, use the rotary switch on
the rear panel of the unit. The UNIT ID must be a unique
number in the network.
3-2-2. How to connect to the Dante
network
The unit can be connected to the Dante network in one of
two ways: Star (Redundant) and Daisy Chain. For this
setting, use the DIP switch 1 on the rear panel of the unit.
3-2-3. IP address
Determines the IP address for identifying this unit from a
computer. For this setting, use the DIP switch 7 and 8 on
the rear panel of the unit.
Any settings you change while the power is on will be
retained and applied the next time you turn the power
on.
MMP1
Mic mute switch
Network switch
Preamp
Computer
Audio signals
Control signals
DAW
Talkback
REDUNDANT
DIP switch 1
down
(default).
DAISY CHAIN
DIP switch 1
up
.
Auto IP
DIP switch 7 and 8
up
.
An IP address is automatically set in the
range of from 169.254.0.1 to
169.254.254.254 (default).
DHCP
DIP switch 7
down
and 8
up
.
An IP address is assigned by the DHCP
server.
Static IP (Auto)
DIP switch 7
up
and 8
down
.
The IP address is set to 192.168.0.xx (xx is
the UNIT ID).
Static IP (Manual)
DIP switch 7 and 8
down
.
Set the IP address using the MMP1 Editor.
Summary of Contents for MMP1
Page 28: ......
