Yamaha MO6 Owner'S Manual Download

Page: 156 / 240

oice mode

erf
ormance

mode

Song mode

Utility mode

File mode

Master mode

attern mode

Mixing V

oice

mode

Ref

erence

Voice Edit mode

Normal Voice Edit Common Edit

156

Owner’s Manual

[F5] LFO (Low Frequency Oscillator)

From these displays, you can make a variety of LFO related settings. As its name suggests, the LFO creates waveforms of a low frequency. These waveforms
can be used to vary the pitch, filter or amplitude to create effects such as vibrato, wah and tremolo.

[SF1] WAVE

Wave

Determines the LFO waveform used to vary the sound.

Settings:

tri, tri+, sawup, sawdwn, squ1/4, squ1/3, squ, squ2/3, squ3/4, trpzp, S/H 1, S/H 2, user

Speed

Determines the speed of the LFO waveform. The higher the value, the faster the speed.

Settings:

0 – 63

TempoSync

Determines whether or not the LFO is synchronized to the tempo of the Arpeggio or sequencer (song or
pattern).

Settings:

off (not synchronized), on (synchronized)

TempoSpeed

This parameter is available only when TempoSync above has been set to “on.” It allows you to make detailed
note value settings that determine how the LFO pulses in sync with the Arpeggio or sequencer.

Settings:

16th, 8th/3 (eighth-note triplets), 16th. (dotted sixteenth notes), 8th, 4th/3 (quarter-note triplets), 8th. (dotted eighth
notes), 4th (quarter notes), 2nd/3 (half-note triplets), 4th. (dotted quarter notes), 2nd (half notes), whole/3 (whole-note
triplets), 2nd. (dotted half notes), 4th x 4 (quarter-note quadruplets; four quarter notes to the beat), 4th x 5 (quarter-note
quintuplets; five quarter notes to the beat), 4th x 6 (quarter-note sextuplets; six quarter notes to the beat), 4th x 7
(quarter-note septuplets; seven quarter notes to the beat), 4th x 8 (quarter-note octuplets; eight quarter notes to the
beat)

The actual length of the note depends on the internal or external MIDI tempo setting.

KeyOnReset

Determines whether or not the LFO is reset each time a note is pressed. The following three settings are
available.

Settings:

off, each-on, 1st-on

off .....................The LFO cycles freely with no key synchronization. Pressing a key starts the LFO wave at whatever phase the

LFO happens to be at that point.

each-on............The LFO resets with each note you play and starts a waveform at the phase specified by the Phase parameter

(below).

1st-on ...............The LFO resets with every note you play and starts the waveform at the phase specified by the Phase parameter

(below). However, if you play a second note while the first is being held, the LFO continues cycling according to
the same phase as triggered by the first note. In other words, the LFO only resets if the first note is released
before the second is played.

RandomSpeed

Determines the degree to which the LFO speed changes at random. A setting of “0” results in the original
speed. Higher values result in a larger degree of speed change.

Settings:

0 – 127

[SF2] DELAY

Delay (Delay Time)

Determines the delay time between the moment you press note on the keyboard and the moment the LFO
comes into effect. A higher value results in a longer delay time.

Settings:

0 – 127

FadeIn (Fade In Time)

Determines the amount of time for the LFO effect to fade in (after the Delay time has elapsed). A higher value
results in a slower fade-in.

Settings:

0 – 127

Hold (Hold Time)

Determines the length of time during which the LFO is held at its maximum level. A higher value results in a
longer Hold time.

Settings:

0 – 127

Time

Key on