V
oice mode
P
erf
ormance
mode
Song mode
Utility mode
File mode
Master mode
P
attern mode
Mixing V
oice
mode
Ref
erence
Voice Edit mode
Normal Voice Edit Element Edit
163
Owner’s Manual
F
CenterKey
Determines the central note or pitch for the Key Follow effect on Amplitude EG. Depending on the EG Time
Sensitivity parameter above, the further away from the Center Key the keys are played, the more the time of the
Amplitude EG deviates from the norm.
When the Center Key is played, the AEG behaves according to its actual settings. The amplitude change
characteristics for other notes will vary in proportion to the EGTime settings.
Settings:
C -2 – G8
n
You can also set the Center Key directly from the keyboard, by holding down the [INFORMATION] button and pressing
the desired key.
[SF5] SCALE
(Amplitude Scaling)
Amplitude Scaling controls the output level (set in the [F4] AMP í [SF1] LVL /PAN display) according to the
positions of the notes on the keyboard. You can divide the entire keyboard by four break points, and assign
different offset values of amplitude to them respectively. Refer to the setting example on page 169.
Settings:
BREAK POINT 1 – 4: C-2 – G8
Settings:
OFFSET 1 – 4: -128 – 0 – +127
n
You can also set the Break Point directly from the Keyboard, by holding down the [INFORMATION] button and pressing
the desired key.
[F5] LFO (Low Frequency Oscillator)
This display gives you a comprehensive set of controls over the LFO for each individual Element. The LFO can be used to create vibrato, wah, tremolo and
other special effects, by applying it to the pitch, filter and amplitude parameters.
Wave
Determines the LFO waveform used to vary the sound.
Settings:
saw, tri, squ
Speed
Determines the speed of the LFO waveform. The higher the value, the faster the speed.
Settings:
0 – 63
KeyOnReset
Determines whether or not the LFO is reset each time a note is played.
Settings:
off, on
KeyOnDelay
Determines the delay time between the moment you play a note on the keyboard and the moment the LFO
comes into effect. A higher value results in a longer delay time.
Settings:
0 – 127
PMod
(Pitch Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the pitch of the sound.
The higher the value, the greater the amount of pitch modulation.
Settings:
0 – 127
FMod
(Filter Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the Filter Cutoff frequency. The
higher the value, the greater the amount of filter modulation.
Settings:
0 – 127
AMod
(Amplitude Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the amplitude or volume of the
sound. The higher the value, the greater the amount of amplitude modulation.
Settings:
0 – 127
FadeInTime
Determines the amount of time for the LFO effect to fade in (after the KeyOnDelay time has elapsed).
A higher value results in a slower fade-in.
Settings:
0 – 127
Center key
Center key
Higher
range
Lower
range
Large
Small
–
+
Amount of AEG
level change
Positive value
Higher range
Lower range
Slower speed
Faster speed
+63
+30
-40
Negative value
When Level Sensitivity is set to 100
Level Sensitivity and Center Key
EG Time Sensitivity and Center Key
saw (sawtooth wave)
squ (square wave)
tri (triangle wave)
Time
Key on
Time
Key on
On
Off
Summary of Contents for MO6
Page 1: ...OWNER S MANUAL MUSIC PRODUCTION SYNTHESIZER EN...
Page 236: ...236 Owner s Manual Memo...
Page 237: ...237 Owner s Manual Memo...
Page 238: ...238 Owner s Manual Memo...
