Yamaha MO6 Owner'S Manual Download

Page: 173 / 240

oice mode

erf

ormance

mode

Song mode

Utility mode

File mode

Master mode

attern mode

Mixing V

oice

mode

Ref

erence

Performance Edit mode

Common Edit

173

Owner’s Manual

[F3] ARP (Arpeggio)

From this display you can set the Arpeggio related parameters.

[SF1] TYPE

Same as in Normal Voice Common Edit. See page 154.

[SF2] LIMIT

[SF3] PLAY FX (Play Effect)

[SF4] OUT CH (Output Channel)

From this display you can set a separate MIDI output channel for the Arpeggio playback data, letting you have
the Arpeggio sound from an external tone generator or synthesizer.

OutputSwitch

When this is set to on, Arpeggio playback data is output via MIDI.

Settings:

on, off

TransmitCh

Determines the MIDI transmit channel for Arpeggio playback data. When set to “KbdCh,” the Arpeggio
playback data is output via the MIDI Keyboard Transmit Channel ([UTILITY]

→

[F5] MIDI

→

KBDTransCh).

Settings:

1 – 16, KbdCh (Keyboard Channel)

[F4] CTL ASN (Controller Assign)

You can assign Control Change numbers to the controllers listed below, letting you use the hardware controllers on the keyboard to alter the sound of
external MIDI devices, via the appropriate MIDI messages. When the MO receives Control Change data corresponding to the settings here, the internal tone
generator responds as if the instrument's controllers were used.

BC (Breath Controller)

The MO does not have a jack to connect a Breath Controller. However, the MO responds as if a Breath
Controller was used when receiving Control Change messages over the Control Change number determined in
this parameter.

RB (Ribbon Controller)

The MO does not have a Ribbon Controller. However, the MO responds as if a Ribbon Controller was used
when receiving Control Change messages over the Control Change number determined in this parameter.

AS1 (Assign 1),
AS2 (Assign 2)

Determines the Control Change number generated when you control the ASSGN 1 (Knob3) and the ASSIGN 2
(Knob4) with both the [PAN/SEND] and [TONE] lamp turned on.

FC1 (Foot Controller 1)

Determines the Control Change number generated when you use the Foot Controller connected to the FOOT
CONTROLLER jack.

FC2 (Foot Controller 2)

The MO has only one jack for connection to a Foot Controller. However, the MO responds as if a 2nd Foot
Controller was used when receiving Control Change messages over the Control Change number determined in
this parameter.

Keep in mind that the functions of these controllers set here are not changed for the internal tone generator. The controller assignments for the MO itself depend on
the settings of the Voices assigned to each Part.

[F6] EFFECT

This menu gives you comprehensive control over the effects. For details on the Effect connections in the Performance mode, see page 143.

[SF1] CONNECT (Connection)

For more information on parameters, refer to page 143.

[SF2] INS SW (Insertion Switch)

The Insertion Effects can be applied to up to three Parts. This display lets you set to which Parts the Insertion
Effects are applied.

[SF4] REVERB

The number of parameters and values available differs depending on the currently selected effect type. Refer
to the separate Data List booklet.

[SF5] CHORUS