Yamaha MO6 Owner'S Manual Download

Page: 174 / 240

oice mode

erf
ormance

mode

Song mode

Utility mode

File mode

Master mode

attern mode

Mixing V

oice

mode

Ref

erence

Performance Edit mode

Part Edit

174

Owner’s Manual

These parameters are for editing the individual Parts that make up a Performance.

Part Edit

[PERFORM]

➞

Performance selection

➞

[EDIT]

➞

Part selection

[F1] VOICE

[SF1] VOICE

You can select a voice for each part.

PartSw (Part Switch)

Set each pat to on or off.

Settings:

on, off

Bank

Determines the Voice Bank (page 40) for each Part.

Number

Determines the Voice Program number for each Part.

[SF2] MODE

Mono/Poly

Determines the playback method of the Voice for each Part—monophonic (single notes only) or polyphonic
(multiple notes).

Settings:

mono, poly

This parameter is not available for the part to which the Drum Voice is assigned.

ArpSwitch (Arpeggio Switch)

Determines whether Arpeggio is on or off for the currently selected Part.

Settings:

on, off

[SF3] LIMIT

NoteLimitH (Note Limit High)

Determines the lowest and highest notes of the keyboard range for each Part. Each Part will only sound for
notes played within its specified range.

Settings:

C -2 – G8

If you specify the highest note first and the lowest note second, for example “C5 to C4,” then the note range covered will
be “C-2 to C4” and “C5 to G8.”

You can set the note by pressing the keyboard while holding the [INFORMATION] button.

NoteLimitL (Note Limit Low)

VelLimitH (Velocity Limit High)

Determines the minimum and maximum values of the velocity range within which each Part will respond. Each
Part will only sound for notes played within its specified velocity range.

Settings:

1 – 127

If you specify the maximum value first and the minimum value second, for example “93 to 34,” then the velocity range
covered will be “1 to 34” and “93 to 127.”

VelLimitL (Velocity Limit Low)

[SF4] PORTA (Portamento)

Determines the Portamento parameters for each Part. Portamento is used to create a smooth transition in pitch
from the first note played on the keyboard to the next.

Switch

Determines whether Portamento is on or off.

Settings:

off, on

Time

Determines the pitch transition time. Higher values result in a longer pitch change time.

Settings:

0 –127

Mode

Determines the Portamento mode.

Settings:

fingr (fingered), full (full time)

fingr (fingered) ......... Portamento is only applied when you play legato (playing the next note before releasing the previous one).
full (full time)............. Portamento is always applied.

These Portamento parameters above are not available for the part to which the Drum voice is assigned.

[SF5] OTHER

PB (Pitch Bend) Upper,
PB (Pitch Bend) Lower

Determines the amount and direction of Pitch Bend range. Details are same as that in the Common Edit
parameters in Normal Voice mode (page 154).

VelSensDpt
(Velocity Sensitivity Depth)

Determines the degree to which the resulting volume
of the tone generator responds to your playing
strength.
The higher the value, the more the volume changes
in response to your playing strength (as shown at
right).

Settings:

0 – 127

127

Depth = 127

Depth = 32

Depth = 64

Depth = 0

When Offset (below) is set to 64:

Actual resulting
velocity (affecting
the tone generator)

Velocity with which you play a note