■
TEST PROGRAM
36
MODX6/MODX7
1. Measurement condition
1-1. Environment
Perform tests under following conditions.
Ordinary temperature (5°C to 40°C)
Ordinary humidity (20% to 90%)
If the test result does not meet the specifications, check again the tests under such conditions as the ordinary temperature (5°C
to 40°C) and ordinary humidity (30% to 90% relative humidity).
1-2. Power voltage
Use PA-150B for the AC adaptor.
The AC power should be 50Hz or 60Hz and the capacity should be 500VA or more.
The voltage should be ±10% of the rating voltage of the adaptor being used.
1-3. Measuring instrument
Make sure that the instruments used for inspections have enough accuracy and precision.
Use the instruments with more than 1M-ohms input impedance.
• Level meter (using JIS-C filter)
• Frequency counter (should be capable of measuring to three places of decimals)
• Oscilloscope
• Oscillator
1-4. Test jig
Following jigs are required for testing.
• Speaker with amplifier
• MIDI cable
• USB cable (A-B type)
• USB flash drive
• Foot pedal (FC3A, FC4A or FC5)
• Foot controller (FC7)
• Monaural plug (150-ohms load) : Noise level check for A/D INPUT jacks.
1-5. Terminal condition
Measure the values at the [PHONES] jack by using a stereo plug unless otherwise specified.
[PHONES] :
Install a measuring plug (L/R ch: 33-ohms load)
OUTPUT [L/MONO]/[R] :
Install a monaural plug (L (MONO)/R ch: 10k-ohms load)
A/D INPUT [L/MONO]/[R] :
Install a monaural plug
1-6. Control condition
Unless otherwise specified, set control knobs as follows. Set others in the default state by turning the power on.
[MASTER VOLUME]
slider :
Max
A/D INPUT [GAIN]
knob :
Max
[USB VOLUME (MONITOR)]
knob : Max
Control Sliders 1–4 :
Max
[FOOT CONTROLLER 1, 2] :
Min
FOOT SWITCH [ASSIGNABLE] :
Off
FOOT SWITCH [SUSTAIN] :
Off
Pitch Bend Wheel :
Center
Modulation Wheel :
Min
1-7. Measurement unit
The analog level unit is 0 dBu = 0.775 Vrms
* If you execute Test No. 24 Factory Set, the setting data and user data will be lost. Be sure to save these data for
backup in advance. (See page 77.)
Summary of Contents for MODX6
