59
MONTAGE6/MONTAGE7
LCD display
Test items and judging conditions
08 : KAT
Checks whether or not the keyboard works properly and the After Touch function works properly by
scaling all keys.
1)
Press the [ENTER] button. “
Scaling Press xx
” is shown on the LCD.
MONTAGE6: C1
MONTAGE7: E0
2)
Press the key specified on the LCD.
After KeyOn is set, the velocity at that time is shown. Also a TONE (1kHz) sound is produced and
the display is changed to the next key test.
When a wrong key is pressed, “
NG
” is shown and no sound is produced.
3)
Check the next keys according to the display.
4)
After checking all keys, “
OK
” is shown on the LCD.
At the same time, the After Touch target value “
<127>
” and current value “
0
” are shown on the
LCD.
5) Press any key and confirm that the After Touch number changes deppending on the key is pressed
deeper.
When 125 of the current value is detected, the displayed target value changes to “
<0>
” and the
displayed current value to “
125
”.
6)
Release the key.
When 0 of the current value is detected, “
OK
” is shown on the LCD.
When OK of the test result is shown, testing is finished and the display is changed to the test item
selection screen.
Note:
When the [EXIT] button is pressed during this test, the display is changed to the test item selec
-
tion screen.
Summary of Contents for Montage 6
