31
“Setup Dialog”
Settings made here control how data is sent between the Multi Part Editor and the MOTIF-RACK or
the 01X. (
1
MIDI In Remote Port ....... Click this and Select a remote MIDI input port.
n
When running Multi Part Editor as an SQ01 plug-in, the remote input port name set in the SQ01 will
be displayed here.
2
MIDI Out Remote Port .... Click this and Select a remote MIDI output port.
n
When running Multi Part Editor as an SQ01 plug-in, the remote output port name set in the SQ01 will
be displayed here.
3
MIDI In Port..................... Click this and Select a MIDI input port.
Data from the MOTIF-RACK will be received on this port.
4
MIDI Out Port .................. Click this and Select a MIDI output port.
Multi Part Editor will control the MOTIF-RACK by sending data on this
port.
5
Device No........................ Required for transmitting/receiving system exclusive data (bulk data)
to and from MOTIF-RACK. Set this to match the device number of the
MOTIF-RACK.
6
Dump Interval ................. Sets the interval between packets of data when transmitting/receiving
bulk data to the MOTIF-RACK.
7
Dial Mouse Control ......... Changes the operation of the parameter knobs.
When “Rotate” is selected, the parameter values (of the panel
“knobs”) are changed by clicking and dragging the mouse in a circular
direction - in the same way as turning an actual knob.
When “Up/Down or Left/Right” is selected, the parameter values (of
the panel “knobs”) are changed by clicking and dragging the mouse
vertically or horizontally - in the same way as operating a slider.
n
The setting made here affects all knobs.
8
OK................................... Click this to use the new settings and close the dialog.
9
Cancel............................. Click this to close the dialog without changing the settings.
1
6
8
2
3
4
5
9
7
