123
MOTIF XS6/MOTIF XS7/MOTIF XS8
[Judgment indication]
OK
09 : PB, MW, RB
TEST
MOTIF XS Test Program
Pitch Bend
Modulation Wheel
Ribbon Controller
OK
OK
OK
NG: No indication
[MIDI code output for judgment result]
OK: A0 0A 02 <==
NG: No output
[How to quit test]
When the judgment is shown and output, the test will be
completed and item selection condition will be selected.
If the judgment is NG on the way, refer to “
D. How to carry
out tests when judged as NG
test program.
[Others]
None
T10:
Foot Controller, Foot Switch
(Test
Code:
A00B00)
[First indication]
Press [ENTER]
10 : FC1/2, Sus/FS
TEST
MOTIF XS Test Program
[Test contents]
Check that [FOOT CONTROLLER 1, 2], [FOOT SWITCH
SUSTAIN] and [FOOT SWITCH ASSIGNABLE] jacks work
normally.
The order of the jacks to be checked is not designated.
[Check item]
Check that values change smoothly and that judgment is OK.
[Judgment indication]
OK
10 : FC1/2, Sus/FS
TEST
MOTIF XS Test Program
yyy: Target value
xxx: Current value
∗
1: When the jack is not connected, “Input FC3”
will be displayed.
No indication will be shown during AD Test.
After the AD Test is completed, “Extract Plug!”
will be displayed.
Foot Controller 1
Foot Controller 2
< yyy > xxx
Foot Switch
< yyy > xxx
Sustain Switch
< yyy > xxx
OK
∗
1
10 : FC1/2, Sus/FS
TEST
MOTIF XS Test Program
Foot Controller 1
Foot Controller 2
Foot Switch
Sustain Switch
OK
OK
OK
OK
NG: No indication
Compare the values of FOOT CONTROLLER 1, 2 input
from the EBUS A/D input with the target values on the LCD.
Compare the ON/OFF of FC3 ON/OFF of FOOT SWITCH
input from the EBUS A/D input with the target values on the
LCD.
[Test method]
Connect the foot controller (FC7) to the [FOOT CONTROLLER
1, 2] jacks. According to an LCD indication as follows, smoothly
return and then press down so that the value will be: 0 (0 to 2)
"
127 (125 to 127).
Connect the foot pedal (FC3) to the [FOOT SWITCH SUSTAIN]
jack. According to an LCD indication as follows, smoothly press
down and then release so that the value will be: 35 or less
"
101
or more.
Connect the foot switch (FC4 or FC5) to the [FOOT SWITCH
ASSIGNABLE] jack and turn the foot switch on/off.
