MOX6/MOX8 Reference Manual
Voice Mode
29
OctaveRange
Specifies the maximum Arpeggio range in octaves.
Settings:
-3 – +0 – +3
Loop
Determines whether the Arpeggio plays through a single time or continuously, while notes are held.
Settings:
off, on
TriggerMode
When this is set to “gate,” pressing the note starts Arpeggio playback and releasing the note stops it. When this is set to
“toggle,” pressing the note starts/stops Arpeggio playback and releasing the note does not affect Arpeggio playback.
Settings:
gate, toggle
AccntVelTh (Accent Velocity Threshold)
Determines the minimum velocity that will trigger the Accent Phrase.
Settings:
off, 1 – 127
AccntStrtQtz (Accent Start Quantize)
Determines the start timing of the Accent Phrase when the Velocity specified in Accent Velocity Threshold above is
received. When this is set to off, the Accent Phrase starts as soon as the Velocity is received. When this is set to on, the
Accent Phrase starts on the beat specified for each Arpeggio type after the Velocity is received.
Settings:
off, on
RandomSFX
Determines whether Random SFX is active or not.
Settings:
off, on
SFXVelOffset (Random SFX Velocity Offset)
Determines the offset value by which the Random SFX notes will be shifted from their original velocities.
Settings:
-64 – +0 – +63
SFXKeyOnCtrl (Random SFX Key on Control)
When this is set to “on,” a special Random SFX sound is played at a pre-programmed velocity. When this is set to “off,”
the Random SFX sound is played at the velocity generated by the playing of each note.
Settings:
off, on
Knob
