MOX6/MOX8 Reference Manual
Utility Mode
146
[SF1] ASSIGN
Determines Controller Assign settings common to the entire system of the MOX6/MOX8. You can assign MIDI Control
Change Numbers to the Knobs on the front panel and the external controllers. For example, you could use the ASSIGN
1 and 2 knobs to control effect depth for two different effects, while using the Foot Controller to control modulation.
These Control Change Number assignments are known as “Controller Assign.”
BC (Breath Controller Control Number)
Determines the Control Change number generated when you use a Breath Controller on an external device connected
to the MOX6/MOX8.
Settings:
off, 1 – 95
RB (Ribbon Controller Control Number)
Determines the Control Change number corresponding to a Ribbon Controller on an external device connected to the
MOX6/MOX8.
Settings:
off, 1 – 95
FC1 (Foot Controller 1 Control Number)
Determines the Control Change number generated when you use the Foot Controller connected to the [FOOT
CONTROLLER] jack. Keep in mind that if the same MIDI Control Change messages as set here are received from an
external device, the internal tone generator also responds to those messages as if the Foot Controller of the instrument
itself was used.
Settings:
off, 1 – 95
FC2 (Foot Controller 2 Control Number)
Determines the Control Change number corresponding to a Foot Controller 2 on an external device connected to the
MOX6/MOX8.
Settings:
off, 1 – 95
AS1 (Assignable 1 Control Number)
AS2 (Assignable 2 Control Number)
Determines the Control Change number generated when you use the ASSIGN 1/2 knobs. Keep in mind that if the same
MIDI Control Change messages as set here are received from an external device, the internal tone generator also
responds to those messages as if the ASSIGN 1/2 knobs of the instrument itself was used.
Settings:
off, 1 – 95
AF1 (Assign Function 1 Control Number)
AF2 (Assign Function 2 Control Number)
Determines the Control Change number generated when you use the ASSIGNABLE FUNCTION [1]/[2] buttons. Keep in
mind that if the same MIDI Control Change messages as set here are received from an external device, the internal tone
generator also responds to those messages as if the ASSIGNABLE FUNCTION [1]/[2] buttons of the instrument itself
was used.
Settings:
off, 1 – 95
[SF2] FT SW (Foot Switch)
From this display you can determine the Control Change number generated by using the Footswitch connected to the
FOOT SWITCH jack.
FS (Foot Switch Control Number)
From this display you can determine the Control Change number generated by using the Footswitch connected to the
FOOT SWITCH [ASSIGNABLE] jack. Keep in mind that if the same MIDI Control Change messages as set here are
received from an external device, the internal tone generator also responds to those messages as if the Footswitch of
the instrument itself was used.
Settings:
off, 1 – 95, arp sw, play/stop, PC inc, PC dec, octave reset
[F4] CTL ASN (Controller Assign)
