MOXF6/MOXF8 Owner’s Manual
Appendix
70
Installing Optional
Hardware
Available devices
The following optional devices can be installed to the MOXF.
Installation locations
Installation Precautions
Before installing the optional hardware, make sure you have
a Phillips screwdriver and ample space to work.
WARNING
• Before beginning installation, switch off the power to the
instrument and connected peripherals, and unplug them from the
power outlet. Installation or removal of any devices should be
started ONLY after the instrument (and any optional hardware)
returns to normal room temperature. Then remove all cables
connecting the instrument to other devices. (Leaving the power
cord connected while working can result in electric shock. Leaving
other cables connected can interfere with work.)
• Be careful not to drop any screws inside the instrument during
installation. (This can be prevented by keeping the optional units
and cover away from the instrument while attaching). If this does
happen, be sure to remove the screw(s) from inside the unit before
turning the power on. Loose screws inside the instrument can
cause improper operation or serious damage. If you are unable to
retrieve a dropped screw, consult your Yamaha dealer for advice.
• Install the optional units carefully as described in the procedure
below. Improper installation can cause shorts which may result in
irreparable damage and pose a fire hazard.
• Do not disassemble, modify, or apply excessive force to board
areas and connectors on optional units. Bending or tampering with
boards and connectors may lead to electric shock, fire, or
equipment failures.
CAUTION
• It is recommended that you wear gloves to protect your hands from
metallic projections on optional units and other components.
Touching leads or connectors with bare hands may cause finger
cuts, and may also result in poor electrical contact or electrostatic
damage.
• Be careful of static electricity. Static electricity discharge can
damage the IC chips. Before you handle the optional units, to
reduce the possibility of static electricity, touch unpainted metal
parts or a ground wire on a device that is grounded.
• Handle the optical units with care. Dropping or subjecting them to
any kind of shock may cause damage or result in a malfunction.
• Do not touch the exposed metal parts in the circuit board. Touching
these parts may result in a faulty contact.
• Be careful not to misplace any of the screws.
• Do not use any screws other than what are installed on the
instrument. Use of incorrect screws can cause damage.
FL512M/FL1024M
(Flash memory expansion module)
Bottom cover for the FL512M/FL1024M
Bottom cover for the FL512M/FL1024M
MOXF6
MOXF8
Summary of Contents for MOXF6
Page 1: ...Owner s Manual EN...
Page 76: ...76 MOXF6 MOXF8 Owner s Manual Memo...
Page 77: ...MOXF6 MOXF8 Owner s Manual 77 Memo...
Page 78: ......