MOXF6/MOXF8 Reference Manual
Pattern Mode
[F1] SETUP
[F4] TIE
[F5] DELETE
[F6] BAK DEL
[F1] CHANGE
[F2] VIEW FLT
[F5] INSERT
[F6] DELETE
110
03: Clear Track
This Job deletes all data of the selected type from the
selected Pattern Track. The types of data to be cleared are
the same as in Song Job. See
04: Normalize Play Effect
This Job rewrites the data in the selected Track so that it incorporates the current Grid Groove settings. After specifying
a Track (TR 01 – 16) to which this Job is applied, press the [ENTER] button to execute this Job.
05: Divide Drum Track
Separates the note events in a drum performance assigned to a specified Track, and places the notes corresponding to
different drum instruments in separate Tracks (Tracks 1 through 8). After specifying a Track (TR 01 – 16) to which this
Job is applied, press the [ENTER] button to execute this Job.
NOTE
This job requires eight empty User Phrases in which to store the separated note data. If there aren’t enough empty Phrases, an
error message appears. If this happens, use the Clear Phrase Job (
) to delete some User Phrases, then try the Job
again.
06: Put Track To Arp (Put Track to Arpeggio)
This Job copies data in the specified measures of a Section/Track for creating Arpeggio data. For details, see
.
01: Copy Pattern
This Job copies all data from a selected source Pattern to a
selected destination Pattern. After specifying the source
Pattern/Section, and the destination Pattern/Section, as well as
setting the checkboxes as necessary, press the [ENTER]
button to execute this Job.
NOTE
If you set the source Section to “all,” the destination Section is
also set to “all” automatically. In this status, execute this Job to
copy the entire source Pattern data to the destination.
Duplicate User Phrase
When this box is checkmarked, User Phrases (if included in the source Pattern) are copied to another User Phrase,
which will be assigned to the destination Pattern.
NOTE
If the source Pattern number is same as the destination Pattern number, User Phrases are not copied to another User Phrase.
Chain
When this box is checkmarked, Pattern chain data (if included in the source Pattern) is copied to the destination Pattern.
[F6] PATTERN (Pattern Job)
Section and Track from which data is to be cleared
Types of data to be cleared
Source Pattern and Section
Destination Pattern and Section