Instrument an
d
control functions
4-13
4
EAU1234K
Han
d
le
b
ar switches
Left
Ri
g
ht
EAU12352
Pass switch “
”
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to “
”, the passing switch has no ef-
fect.
EAU12401
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU12461
Turn si
g
nal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “
”
Press this switch to sound the horn.
EAU68270
Start/En
g
ine stop switch “
/
/
”
To crank the engine with the starter,
set this switch to “
”, and then slide
the switch toward “
”. See page 6-1
for starting instructions prior to starting
the engine.
Set this switch to “
” to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU44712
The engine trouble warning light and
ABS warning light (ABS model only)
may come on when the key is turned to
“ON” and the start switch is pushed,
but this does not indicate a malfunc-
tion.
EAU12735
Hazar
d
switch “
”
With the key in the “ON” or “
” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
1. Pass switch “
”
2. Dimmer switch “
/
”
3. Turn signal switch “
/
”
4. Horn switch “
”
1. Start/Engine stop switch “
/
/
”
2. Hazard switch “
”
2
3
4
1
1
2
U1WS2AE0.book Page 13 Monday, December 7, 2015 2:00 PM
