MU128
28
Battery Low!
The battery voltage (for internal memory backup) may be too low. Replace the battery with the
new one.
Check Sum ERROR!
The checksum of the received System Exclusive message is incorrect. Check the size of the
checksum of the message and transmitting again.
HOST Is Offline!
This message appears when the host computer is not turned on, the connecting cable is not
properly connected, or the sequencing software is not active.
Illegal Data!
A data error resulted during reception of MIDI massages. Try transmitting the data again, or
turn the MU128 off and back on again.
MIDI Buffer Full!
Too mach MIDI data is being received by the MU128 at one time. Reduce the amount of data
being sent to the MU128.
No Parameter
The selected parameter cannot be displayed with the show MIDI Data function.
No RecallPerform!
This message appears if you use the Recall function in the Performance Edit mode when there
is no edited performance data to be recalled.
Not Available
Drum Voices cannot be selected when the Sound Module mode is set to "PFM."
Not Available with PLG
The selected XG Plug-in board does not have Voice for the selected Voice category.
PB Com ERROR!
l
An error occurred in the communication between the MU128 and the XG Plug-in board. Turn
off the power and check that the board is properly installed.
l
The XG Plug-in board was unable to process incoming MIDI data, probably because too
much data was received too quickly. If possible, avoid sending unnecessary data and
reduce the amount of data sent to the MU128.
Rcv CH Is OFF!
The selected parameter for use with the Show MIDI Data function cannot be converted to a
MIDI message value since the Receive Channel for the Part is off. Set the Receive Channel to
an appropriate value.
Select BANK Or PGM# First
This message appears if you use the Show MIDI Data function when the Sound Module mode
is set to "PFM" and both the bank number and program number are selected by the cursors.
(The Show MIDI Data function cannot display both values simultaneously.) Move the cursor to
one parameter or the other (bank number or program number) and use the Show MIDI Data
function to check each value individually.
Select drumS1
•¨
4 When You Edit
This message appears if you attempt to edit a Drum Voice for a Part whose Part mode has
been set to "drum." Set the part mode to one of the drum setups ("drumS1-S4") in order to edit
the Drum Voice.
SysEx Adrs ERROR!
The data of the received System Exclusive message is incorrect. Check the address of the
message and try transmitting again.
SysEx Data ERROR!
The data of the received System Exclusive message is incorrect. Check the data of the
message (as to whether it requires an MSB or LSB header) and try transmitting again
SysEx Size ERROR!
The data of the received System Exclusive message is incorrect. Check the size of the
message and try transmitting again.
This Parameter Isn' t Excl Data
The selected parameter cannot be displayed with the Show MIDI Data function.
Summary of Contents for MU128
