MX12/6, 20/6 — Owner’s Manual
Applications
9
Applications
Example 1) Sound Reinforcement for a live
performance
Procedure
q
Connect line input devices or microphones to the INPUT jacks and connect a power amp, that is
connected to the main speakers, to the ST OUT Jacks.
w
Use the GAIN Control on each channel to adjust the level of the input signal from the device or
microphone that is connected to the input channel (refer to page 2), and use the Channel Fader to
adjust the level of the output signal that is sent to the Master Section. Basically, you should set the
Channel Fader close to the “0” position.
e
Press each channel’s “ST” GROUP Select Switch.
r
Use the ST Master Fader to adjust the level of the signal sent to the power amplifier. Basically, you
should set the Master Fader close to their “0” position.
t
Use the volume control(s) on the power amp to adjust the volume of the speakers.
If necessary, use a monitoring device (a pair of headphones, monitor speakers, etc.), a recording device,
effector, etc.
ST OUT
AUX 1
SEND
AUX 2 (PRE)
SEND
INSERT I/O
C-R/PHONES
TAPE IN
REC OUT
RETURN
EFFECT
SEND
INPUT
GROUP OUT
1 – 4
MONO OUT
Microphone, Line Input
GROUP 1-4 Faders
CD Recorder, DAT, etc.
Sub Woofer, etc.
Main Speakers
Effector
Power Amplifier
Power Amplifier
Effector
ST Master Fader
C-R/PHONES Output and Meter Select Switch
Monitor Speakers
Headphones
Set the POST Switch to “
?
”
(AUX2=PRE).
Group Select Switches
Channel Faders
Power Amplifier
MTR
