MX49 MX61 MX88 Reference Manual
47
Part Edit
NOTE
Parameters that can be edited in the Part Select display are same as the parameters of the Part Edit display.
1
Part**
Indicates the current display is Part Edit. In the ** column, the number of the selected Part is indicated. You can change
the Part in this display by using the Category buttons ([1] – [16]).
2
Display to be edited
Indicates the display name selected for editing in Part Edit.
3
Page indicator
Indicates that the display has several pages. You can call up the previous/next page by using the Cursor [
u
]/[
d
]
buttons.
4
Parameter
Indicates and allows editing of the selected parameter. A single parameter is indicated in each page. You can change
the value of the parameter by using the [DATA] dial or the [INC/YES]/[DEC/NO] buttons.
Operation
Press [EDIT]
Select “02:Part” with Cursor [
d
] button
Press [E
N
TER]
Select Part with
Category buttons ([1] – [16])
Select display to be edited with Cursor [
u
]/[
d
] buttons
Press
[E
N
TER]
Edit parameters in selected display
Play Mode
Parameter
Description
Volume
Determines the output level of each Part.
Settings:
0 – 127
Pan
Determines the stereo pan position of each Part.
Settings:
L63 (far left) – C (center) – R63 (far right)
NoteShift
Determines the pitch (key transpose) setting for each Part in semitones.
Settings:
-24 – +0 – +24
Detune
Determines the fine tuning for each Part.
Settings:
-12.8Hz – +0.0Hz – +12.7Hz
ChoSend
(Chorus Send)
Determines the Send level of each Part signal sent to the Chorus effect. The higher the value, the more
pronounced the Chorus effect.
Settings:
0 – 127
RevSend
(Reverb Send)
Determines the Send level of each Part signal sent to the Reverb effect. The higher the value, the more
pronounced the Reverb effect.
Settings:
0 – 127
DryLevel
Determines the level of the selected Part which has not been processed with the System Effect (Chorus,
Reverb).
Settings:
0 – 127
InsSw
(Insertion Effect Switch)
Determines the Parts available for the Insertion Effect. When this switch is set to on, the Insertion Effect of
the Voice assigned to the Part is enabled. The Insertion Effect can be applied to a maximum of four Parts
of the Performance.
Settings:
off, on
Part01
*
Play
*
Mode
a
*********
Volume=127
3
1
4
2
