MX49 MX61 MX88 Reference Manual
48
Mono/Poly
Selects monophonic or polyphonic playback for each Part. Monophonic is for playing single notes only,
while polyphonic is for playing multiple simultaneous notes.
Settings:
mono, poly
NOTE
This parameter is not available for the Parts to which Drum Voices have been assigned.
PortaSw
(Portamento Switch)
Determines whether Portamento is applied to each Part or not.
Settings:
off, on
PortaTime
(Portamento Time)
Determines the pitch transition time. Higher values result in a longer pitch change time, or a slow speed.
Settings:
0 – 127
PB Upper
(Pitch Bend Range Upper)
PB Lower
(Pitch Bend Range Lower)
Determines the maximum pitch bend range for each Part in semitones.
Settings:
-48 – +0 – +12 (semitone)
Assign1
(Assign 1 Value)
Assign2
(Assign 2 Value)
Determines the value of the functions assigned to the ASSIGN 1/2 knobs.
Settings:
-64 – +0 – +63
NOTE
The functions assigned to the ASSIGN 1/2 Knobs can be set in the Ctrl Set display (
) of Voice
Edit.
Filter/ EG
Parameter
Description
Cutoff
Determines the cutoff frequency of the filter for each Part.
Settings:
-64 – +0 – +63
Resonance
Determines the amount of filter resonance.
Settings:
-64 – +0 – +63
FEG Attack
(FEG Attack Time)
FEG Decay
(FEG Decay Time)
FEG Sustain
(FEG Sustain Level)
FEG Release
(FEG Release Time)
FEG Depth
This allows you to make all time and level settings for the Filter EG, which determine how the tonal quality
of the sound changes over time. These parameters can be used to control the change in cutoff frequency
from the moment a note is pressed on the keyboard to the moment the sound stops. Keep in mind that
changes in the tonal quality also depend on the Resonance setting above.
NOTE
For details on FEG, see the “Synthesizer Parameter Manual” PDF document.
NOTE
This parameter is not available for Parts to which Drum Voices have been assigned.
Settings:
-64 – +0 – +63
AEG Attack
(AEG Attack Time)
AEG Decay
(AEG Decay Time)
AEG Sustain
(AEG Sustain Level)
AEG Release
(AEG Release Time)
This allows you to make all time and level settings for the Amplitude EG, which determine how the volume
of the sound changes over time. Using the AEG, you can control the transition in volume from the
moment the sound starts is to the moment the sound stops.
NOTE
For details on FEG, see the “Synthesizer Parameter Manual” PDF document.
NOTE
The “Sustain” and “Release” parameters are not available for Parts to which Drum Voices have been
assigned.
Settings:
-64 – +0 – +63
Parameter
Description
