MX49 MX61 MX88 Reference Manual
49
From this display you can set how each individual Part responds to various MIDI data, such as Control Change and
Program Change messages. When the relevant parameter is set to “on,” the corresponding Part responds to the
appropriate MIDI data. The setting value for all parameters is “off” or “on.”
Arp Select (Arpeggio Select)
Parameter
Description
Switch
(Arpeggio Switch)
Determines whether Arpeggio is on or off for the selected Parts. The Arpeggio can be applied to a
maximum of two Parts of the Performance.
Settings:
off, on
Hold
(Arpeggio Hold)
Determines whether the Arpeggio continues cycling after the keys are released. For details, see the
“Synthesizer Parameter Manual” PDF document.
Settings:
sync-off, off, on
Category
(Arpeggio Category)
Determines the desired Arpeggio category.
Settings:
Refer to “Arpeggio categories” (
) in “Basic Structure.”
Type
(Arpeggio Type)
Determines the desired Arpeggio type by specifying the number.
Settings:
Refer to the “Data List” PDF document.
MIDI Out
(Arpeggio MIDI Output
Switch)
Determines whether Arpeggio playback data is output via MIDI.
Settings:
off, on
Receive Switch
Parameter
Description
BankSel
(Bank Select)
Determines whether Bank Select MSB/LSB messages for the Voice assigned to each Part are received or
not.
PrgChange
(Program Change)
Determines whether Program Change messages for the Voice assigned to each Part are received or not.
CtrlChange
(Control Change)
Determines whether Control Change messages are received or not.
NOTE
When this parameter is set to off, the parameters related to the Control Change will not be able to be
edited.
Vol/Exp
(Volume/Expression)
Determines whether Control Number 7 (Volume)/Control Number 11 (Expression) messages are received
or not.
Pan
Determines whether Control Number 10 (Pan) messages are received or not.
Sustain
Determines whether Control Number 64 (Sustain) messages are received or not. This parameter is not
available for the Parts to which Drum Voices have been assigned.
PB
(Pitch Bend)
Determines whether MIDI messages generated by using the Pitch Bend Wheel are received or not.
MW
(Modulation Wheel)
Determines whether MIDI messages generated by using the Modulation Wheel are received or not.
AS1
(Assign 1)
AS2
(Assign 2)
Determines whether MIDI messages generated by using the ASSIGN 1/ASSIGN 2 (Knob 3/Knob4) are
received or not.
FS
(Foot Switch)
Determines whether MIDI messages generated by using the optional foot switch connected to the
[SUSTAIN] jack on the rear panel are received or not.
FC1
(Foot Controller 1)
Determines whether MIDI messages generated by using the optional foot controller connected to the
[FOOT CONTROLLER] jack on the rear panel are received or not.
FC2
(Foot Controller 2)
Determines whether MIDI messages for Foot Controller 2 are received or not.
BC
(Breath Controller)
Determines whether MIDI Breath Controller messages are received or not.
RB
(Ribbon Controller)
Determines whether MIDI Ribbon Controller messages are received or not.
