ENGLISH
MY8-SDI-D Owner’s Manual
7
• If more than two GROUP SELECT switches are set to ON, only the first two switches (in
ascending order) will actually be on.
For example, if SW2, SW3, and SW4 are set to ON, Group 2 and Group 3 audio will be
input to slot channels 1-4 and 5-8 respectively, and Group 4 audio will not be input.
B
SYNC Switch (SW5)
Typically set this switch to OFF.
OFF:
An audio clock will be generated based on the phase data of the embedded
audio.
ON:
An audio clock will be generated from video signals.
If the SYNC switch is set to ON, the phase between audio groups may not be
identical. Set this switch to ON only if you cannot input audio with the switch set
to OFF.
C
MUTE Switch (SW6)
Typically set this switch to OFF.
OFF:
Audio will not be muted regardless of whether or not an HD-SDI input
error is detected.
ON:
Audio will be muted if an HD-SDI input error is detected (the STATUS LED
lights up in a color other than green). Use this setting if you want to use muted
audio to indicate an error.
Note:
Keep in mind that connecting or disconnecting a cable may cause noise even if this switch
is set to ON.
D
ERROR FILTER Switch (SW7)
Typically set this switch to OFF. This switch is used to analyze the causes of
errors.
ch1-4
ch5-8
ON
1 2 3 4 5 6 7 8
SDI signal
Slot (host device)
input channels
Group2: ch5-8
Group3: ch9-12
Group1: ch1-4
Group4: ch13-16
